›› 2015, Vol. 36 ›› Issue (S2): 383-388.doi: 10.16285/j.rsm.2015.S2.053

• 基础理论与实验研究 • 上一篇    下一篇

生态护坡基材土-岩接触面原位剪切试验研究

丁 瑜1, 2, 3,杨 奇4,夏振尧1, 2, 3,许文年1, 2, 3   

  1. 1. 三峡大学 三峡库区生态环境教育部工程研究中心,湖北 宜昌 443002;2. 三峡大学 三峡地区地质灾害与生态环境湖北省协同创新中心,湖北 宜昌 443002;3. 三峡大学 三峡库区地质灾害教育部重点实验室,湖北 宜昌 443002;4. 中国电建集团 贵阳勘测设计研究院有限公司,贵州 贵阳 550081
  • 收稿日期:2014-08-31 出版日期:2015-08-31 发布日期:2018-06-14
  • 作者简介:丁瑜,男,1980年生,博士,副教授,主要从事滑坡机制与治理、边坡加固、岩石风化方面的研究工作
  • 基金资助:
    国家自然科学基金(No.41002100,No.41202250);湖北省教育厅优秀中青年科技创新团队计划项目(No.T201304);三峡库区生态环境教育部工程研究中心开放基金(No.KF2013-04)。

In-situ shear tests on base material soil-rock interface in ecological slope protection system

DING Yu1, 2, 3, YANG Qi4, XIA Zhen-yao1, 2, 3, XU Wen-nian1, 2, 3   

  1. 1. Engineering Research Center of Eco-environment in Three Gorges Reservoir Region of Ministry of Education, China Three Gorges University, Yichang, Hubei 443002, China; 2. Collaborative Innovation Center for Geo-hazards and Eco-environment in Three Gorges Area of Hubei Province, China Three Gorges University, Yichang, Hubei 443002, China; 3. Key Laboratory of Geological Hazards on Three Gorges Reservoir Area of Ministry of Education, China Three Gorges University, Yichang, Hubei 443002, China; 4. Guiyang Engineering Corporation Limitied of Power China, Guiyang, Guizhou 550081, China
  • Received:2014-08-31 Online:2015-08-31 Published:2018-06-14

摘要: 基材土-岩接触面剪切力学性能是生态护坡体系长久稳定的关键,相关研究可为解决基材脱落难题、完善生态防护技术体系提供必要依据和指导。采用自制的原位剪切仪对4种不同粗糙起伏的基材土-岩接触面进行了原位剪切试验,结果表明,基材土-岩接触面剪切应力-位移表现出典型的软化特性,具有明显的初始线弹性变形、弹塑性变形、峰后软化以及残余剪切变形4个阶段。分析发现,文中试验条件下凸起高度算数平均偏差Ra在4 mm以下时,峰值剪切强度增加速度较快,随后呈逐渐减弱趋势;残余剪切强度、峰值剪切位移以及进入残余阶段的剪切位移与粗糙凸起高度算数平均偏差呈近线性正相关关系。可见实施生态护坡时合理地控制坡面粗糙起伏,有助于提高土-岩接触面峰值剪切强度和残余剪切强度,改善其变形性能,对防护体系的长期整体稳定具有促进作用。

关键词: 生态护坡基材, 土-岩接触面, 原位剪切试验, 剪切软化, 粗糙度

Abstract: Shear characteristic of base material soil-rock interface plays a key role for long-term stability of ecological slope protection system. Related research on this can provide necessary basis and guidance for resolving the substrate failure and improving the ecological protection technology. The self-made in-situ shear apparatus is used in the field shear tests of 4 groups of base material soil-rock interfaces with different roughnesses. Experimental results show that shear stress-displacement of the base material soil-rock interface is characterized by typical shear softening, including 4 stages of initial linear elastic deformation, elastic plastic deformation, the post-peak softening and residual shear deformation. Under the test conditions, it is found that the peak shear strength increases fast when the arithmetic average deviation of asperity (Ra) is about less than 4 mm. For the higher Ra, the increasing gradient shows a slower trend. Residual shear strength, peak shear displacement and shear displacement stepping to the residual stage show the nearly linear positive correlation with Ra. Therefore, for a specific implementation of ecological slope protection, the reasonable control of slope surface roughness will contribute to increasing the peak and residual shear strength of soil-rock interface, so as to improve the deformation performance and the long-term stability of the protection system.

Key words: base material for ecological slope protection, soil-rock interface, in-situ shear test, shear softening, roughness

中图分类号: 

  • TU 443
[1] 夏才初, 喻强锋, 钱 鑫, 桂 洋, 庄小清. 常法向刚度条件下岩石节理剪切−渗 流特性试验研究[J]. 岩土力学, 2020, 41(1): 57-66.
[2] 王鹏飞, 谭文辉, 马学文, 李子建, 刘景军, 武洋帆, . 不同粗糙度和隙宽贯通充填裂隙 渗流特性试验研究[J]. 岩土力学, 2019, 40(8): 3062-3070.
[3] 周 辉, 程广坦, 朱 勇, 张春生, 卢景景, 张传庆, 章颖辉, . 基于3D雕刻技术的岩体结构面剪切各向异性研究[J]. 岩土力学, 2019, 40(1): 118-126.
[4] 杨圣奇,陆家炜,田文岭,唐劲舟,. 不同节理粗糙度类岩石材料三轴压缩力学特性试验研究[J]. , 2018, 39(S1): 21-32.
[5] 赵婷婷,冯云田,王 敏,王 勇,. 基于改进粗糙表面Greenwood-William 接触模型的离散元方法[J]. , 2018, 39(9): 3440-3452.
[6] 李正伟,张延军,张 驰,许天福,. 花岗岩单裂隙渗流传热特性试验[J]. , 2018, 39(9): 3261-3269.
[7] 熊 峰,孙 昊,姜清辉,叶祖洋,薛道锐,刘乳燕,. 粗糙岩石裂隙低速非线性渗流模型及试验验证[J]. , 2018, 39(9): 3294-3302.
[8] 陈 琛,冷伍明,杨 奇,金子豪,聂如松,邱 鋆,. 混凝土桩-泥皮-砂土接触面力学特性试验研究[J]. , 2018, 39(7): 2461-2472.
[9] 张文泉,袁久党,王忠昶,朱纪明,. 采动裂隙岩体压剪渗透规律试验研究[J]. , 2017, 38(9): 2473-2479.
[10] 宋磊博,江 权,李元辉,杨成祥,冉曙光,王百林,刘 挺,. 基于剪切行为结构面形貌特征的描述[J]. , 2017, 38(2): 525-533.
[11] 王昌硕,王亮清,葛云峰,梁 烨,孙自豪,董曼曼,张 楠. 基于统计参数的二维节理粗糙度系数非线性确定方法[J]. , 2017, 38(2): 565-573.
[12] 孙可明,辛利伟,翟 诚,张树翠,李天舒. 考虑三维形貌特征粗糙裂隙加卸载渗流规律研究[J]. , 2016, 37(S2): 161-166.
[13] 刘日成 ,蒋宇静 ,李 博 ,王肖珊 ,徐帮树 ,蔚立元,. 基于逆Broyden秩1拟牛顿迭代法的岩体裂隙网络渗流特性研究[J]. , 2016, 37(1): 219-228.
[14] 罗战友 ,杜时贵 ,黄 曼,. 岩石结构面粗糙度系数尺寸效应的推拉试验研究[J]. , 2015, 36(12): 3381-3386.
[15] 刘 杰,李建林,胡 静,蔡 健,赵宗勇. 劈裂砂岩有、无砂粒填充条件下的多因素对渗流量影响对比分析[J]. , 2014, 35(8): 2163-2170.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 殷 杰,高玉峰,洪振舜. 连云港软黏土的不排水强度试验研究[J]. , 2009, 30(11): 3297 -3301 .
[2] 陈绍杰,郭惟嘉,杨永杰. 煤岩蠕变模型与破坏特征试验研究[J]. , 2009, 30(9): 2595 -2598 .
[3] 赵炼恒,罗 强,李 亮,杨 峰,但汉成. 层状岩体边坡动态稳定性拟静力上限分析[J]. , 2010, 31(11): 3627 -3634 .
[4] 刘小丽,张丹丹,刘 凯,苏媛媛. 一种直剪式模型试验设备的设计及应用[J]. , 2010, 31(S2): 475 -480 .
[5] 康永君,杨 军,宋二祥. 地震作用下边坡安全系数时程计算及参数研究[J]. , 2011, 32(1): 261 -268 .
[6] 卢坤林,杨 扬. 考虑位移影响的主动土压力近似计算方法[J]. , 2009, 30(2): 553 -557 .
[7] 李荣建,于玉贞,吕 禾,李广信. 饱和砂土地基上抗滑桩加固边坡的动力离心模型试验研究[J]. , 2009, 30(4): 897 -902 .
[8] 肖成志,孙建诚,李雨润,刘晓朋. 三维土工网垫植草护坡防坡面径流冲刷的机制分析[J]. , 2011, 32(2): 453 -458 .
[9] 周万欢 ,殷建华. 上覆压力和剪胀作用下土钉抗拔的有限元模拟[J]. , 2011, 32(S1): 691 -0696 .
[10] 钱建固 ,黄茂松. 土体塑性各向异性的微宏观机理分析[J]. , 2011, 32(S2): 88 -93 .