›› 2018, Vol. 39 ›› Issue (5): 1564-1572.doi: 10.16285/j.rsm.2017.0887

• 基础理论与实验研究 • 上一篇    下一篇

南海北部陆坡软黏土动力应变-孔压特性试验

年廷凯1, 2, 3，焦厚滨1，范 宁1，郭兴森1，贾永刚3   

  1. 1. 大连理工大学 海岸和近海工程国家重点实验室，辽宁 大连 116024； 2. 中国矿业大学 深部岩土力学与地下工程国家重点实验室，江苏 徐州 221008； 3. 中国海洋大学 山东省海洋环境地质工程重点实验室，山东 青岛 266100
  • 收稿日期:2017-05-05 出版日期:2018-05-11 发布日期:2018-06-12
  • 作者简介:年廷凯，男，1971年生，博士，教授，博士生导师，主要从事海洋岩土力学与能源岩土工程、工程地质灾害与地震岩土工程方面的教学和科研工作。
  • 基金资助:

    国家自然科学基金资助项目（No. 51579032，No. U1765107，No. 41427803）；深部岩土力学与地下工程国家重点实验室基金资助项目 （No. SKLGDUEK1307）；山东省海洋环境地质工程重点实验室基金资助项目（No. MEGE1603）。

Experiment on dynamic strain-pore pressure of soft clay in the northern slope of South China Sea

NIAN Ting-kai1, 2, 3, JIAO Hou-bin1, FAN Ning1, GUO Xing-sen1, JIA Yong-gang3   

  1. 1. State Key Laboratory of Coastal and Offshore Engineering, Dalian University of Technology, Dalian, Liaoning 116024, China; 2. State Key Laboratory for Geomechanics and Deep Underground Engineering, China University of Mining and Technology, Xuzhou, Jiangsu 221008, China; 3. Shandong Provincial Key Laboratory of Marine Environment and Geological Engineering, Ocean University of China, Qingdao, Shandong 266100, China
  • Received:2017-05-05 Online:2018-05-11 Published:2018-06-12
  • Supported by:

    This work was supported by the National Natural Science Foundation of China (51579032, U1765107, 41427803), the State Key Laboratory of Geomechanics and Underground Engineering (SKLGDUEK1307) and the Shandong Provincial Key Laboratory of Marine Environment and Geological Engineering (MEGE1603).

PDF (Chinese)

526

摘要： 针对南海北部陆坡原状软黏土，开展了不同偏压固结比 和循环应力比CSR条件下的动三轴试验，探究了动荷载作用下试样的残余动应变、残余动孔压与循环振次的变化规律；综合考虑试验过程中残余动应变和残余动孔压的关联性，提出了基于动应变-孔压模式的动三轴试验破坏标准，并采用微观电镜扫描（SEM）图像揭示其作用机制。研究表明：在给定 条件下，CSR值不同，残余动应变随循环振次的发展趋势呈现出显著差异性，而残余动孔压随循环振次的变化规律基本一致；随着 的增加，CSR临界值逐步增大，相应的最终残余动应变逐渐减小，而残余动应变-动孔压曲线也表现出相似特征；将传统的应变值破坏标准扩展至由应变-孔压曲线拐点控制的破坏区间，可以有效界定破坏振次并描述试样的完整破坏过程，揭示动荷载条件下试样内在的有效应力-应变-孔压互馈机制。上述研究成果将为南海北部陆坡软黏土软化-孔压模型的建立、海洋地质灾害评价与预测、海洋工程基础设计提供可靠参考。

关键词: 南海北部陆坡, 动三轴试验, 残余动孔压, 残余动应变, 破坏标准

Abstract: Referring to the original soft clay in the northern slope of South China Sea, the dynamic triaxial tests were carried out under different conditions of consolidation ratio and cyclic stress ratio CSR. The development rule of the residual dynamic strain, residual pore water pressure and the relationship between them were discussed. Considering the correlation between residual strain and residual pore pressure in the test process, the failure standard of dynamic triaxial test based on strain-pore pressure mode was proposed. The mechanism of mutual feed and its interaction mechanism were revealed by the scanning electron microscopy (SEM) technique. The research results indicate that under the condition of designated and different CSR, the development trends of the residual dynamic strain and cyclic vibration frequency curves show a significant difference, while the change laws of the residual dynamic pore pressure and cyclic vibration frequency curve are basically the same. With the increase of , the critical value of CSR gradually increases, while the final residual dynamic strain gradually decreases. The similar characteristics of changing law can also be found from the curve representing the relationship between residual dynamic strain and residual pore pressure. Furthermore, the conventional failure standard based on strain value is extended to the failure region controlled by the inflection point of the strain-pore pressure curve, which can effectively define the failure vibration frequency and completely describe the whole failure process of the specimen, even reveal the inherent mutual feedback mechanism among effective stress, strain and pore pressure. Research results from this study can provide reliable reference for the establishment of dynamic softening model in soft clay, the evaluation and prediction of marine geological hazards, and the foundation design of ocean engineering in the northern slope of South China Sea.

Key words: northern slope of South China Sea, dynamic triaxial test, residual dynamic strain, residual pore pressure, failure standard

中图分类号: 

  • TU 411

[1] 杨志浩, 岳祖润, 冯怀平, . 非饱和粉土路基内水分迁移规律试验研究[J]. 岩土力学, 2020, 41(7): 2241-2251.
[2] 王康宇, 庄妍, 耿雪玉, . 铁路路基粗粒土填料临界动应力试验研究[J]. 岩土力学, 2020, 41(6): 1865-1873.
[3] 梁珂, 陈国兴, 刘抗, 王彦臻, . 饱和珊瑚砂最大动剪切模量的 循环加载衰退特性及预测模型[J]. 岩土力学, 2020, 41(2): 601-611.
[4] 梁珂, 何杨, 陈国兴, . 南沙珊瑚砂的动剪切模量和阻尼比特性试验研究[J]. 岩土力学, 2020, 41(1): 23-31.
[5] 梁 珂, 陈国兴, 何 杨, 刘景儒, . 基于相关函数理论的动模量和阻尼比计算新方法[J]. 岩土力学, 2019, 40(4): 1368-1376.
[6] 裴向军, 朱 凌, 崔圣华, 张晓超, 梁玉飞, 高会会, 张子东. 大光包滑坡层间错动带液化特性及 滑坡启动成因探讨[J]. 岩土力学, 2019, 40(3): 1085-1096.
[7] 王丽艳, 巩文雪, 曹晓婷, 姜朋明, 王炳辉. 砾钢渣抗液化特性试验研究[J]. 岩土力学, 2019, 40(10): 3741-3750.
[8] 周恩全, 王琼, 宗之鑫, 陆建飞. 饱和橡胶砂动力特性动三轴试验研究[J]. 岩土力学, 2019, 40(10): 3797-3804.
[9] 李 宣, 孙德安，张俊然,. 吸力历史对非饱和粉土动力变形特性的影响[J]. , 2018, 39(8): 2829-2836.
[10] 张修照，巫尚蔚，张 超，杨春和，. 不同固结条件下尾矿动孔压演化规律[J]. , 2018, 39(3): 815-822.
[11] 黄 娟，丁祖德，袁铁映，赵 丹，彭立敏,. 循环荷载作用下泥炭质土的动变形特性试验研究[J]. , 2017, 38(9): 2551-2558.
[12] 刘汉龙，刘 平，杨 贵，肖 杨，刘彦辰，. 高聚物胶凝堆石料动残余变形特性试验研究[J]. , 2017, 38(7): 1863-1868.
[13] 李 博，黄茂松，. 掺有橡胶粉末砂土液化特性的动三轴试验研究[J]. , 2017, 38(5): 1343-1349.
[14] 丁祖德，黄 娟，袁铁映，彭立敏，王志良,. 昆明泥炭质土动剪切模量与阻尼比的试验研究[J]. , 2017, 38(12): 3627-3634.
[15] 崔明娟，郑俊杰，赖汉江. 菌液注射方式对微生物固化砂土动力特性影响试验研究[J]. , 2017, 38(11): 3173-3178.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
版权所有 © 《岩土力学》编辑部
地址：湖北武汉武昌小洪山中国科学院武汉岩土力学研究所(430071)　邮编：200042　电话：027-87198484, 87199252, 87199253, 87198752　E-mail: ytlx@whrsm.ac.cn
本系统由北京玛格泰克科技发展有限公司设计开发