岩石节理倾角和间距对隧道掘进机破岩特性影响的试验研究

›› 2012, Vol. 33 ›› Issue (6): 1640-1646.

岩石节理倾角和间距对隧道掘进机破岩特性影响的试验研究

邹飞^{1, 2}，李海波¹，周青春¹，莫振泽¹，朱小明¹，牛磊¹，杨风威¹

1. 中国科学院武汉岩土力学研究所岩土力学与工程国家重点实验室，武汉 430071； 2. 贵州省质安交通工程监控检测中心有限责任公司，贵阳 550000

收稿日期:2011-01-10 出版日期:2012-06-11 发布日期:2012-06-14
作者简介:邹飞，男，1983年生，博士研究生，主要从事岩石动力学方面的研究工作
基金资助:
国家杰出青年科学基金(No. 51025935)；国家重点基础研究发展规划(973)(No. 2010CB732001)。

Experimental study of influence of joint space and joint angle on rock fragmentation by TBM disc cutter

ZOU Fei^{1, 2}，LI Hai-bo¹，ZHOU Qing-chun¹，MO zhen-ze¹，ZHU Xiao-ming¹，NIU Lei¹，YANG Feng-wei¹

1. State Key Laboratory of Geomechanics and Geotechnical Engineering, Institute of Rock and Soil Mechanics, Chinese Academy of Sciences, Wuhan 430071, China; 2. Guizhou Zhian Traffic Engineering Monitor & Test Center Co., Ltd., Guiyang 550000, China

Received:2011-01-10 Online:2012-06-11 Published:2012-06-14

摘要/Abstract

摘要： 为了研究岩体节理参数（节理间距和节理倾角）对全断面岩石掘进机（TBM）盘形滚刀破岩效果的影响，对实际条件进行简化，在改进的试验装置上进行压头作用下相似材料的变形、破坏试验。采集整个加载过程中压头的侵入深度和荷载数据，并采用相机实时拍摄，获得试件表面破坏的发展过程以及最终破坏形态。试验结果表明，当节理倾角一定时，随着节理间距增大，达到跃进点的贯入荷载值增加，侵入功以及主裂纹扩展能量也都呈增大趋势，当 =0°、90°时，抗侵入系数基本一致，当 = 30°、60°时，抗侵入系数逐渐增大。当节理间距一定时，随着角度的增加，跃进点荷载、抗侵入系数、侵入功以及主裂纹扩展能量都呈现先减小后增大趋势，在 =30°时，各值都为最小值。根据试件破坏后形态分析发现，节理的空间特征对裂纹扩展模式有明显的控制作用，对破坏区域的形成也有明显的限制。

关键词: 隧道掘进机, 盘形滚刀, 节理参数, 贯入荷载

Abstract: To study the rock joint parameters, joint space and joint angle of rock fragmentation by full face rock tunnel boring machine (TBM) disc cutter, the test of high-strength gypsum specimen penetrated by wedge indentation is applied. Data of penetration depth and loads during the loading process are collected. Shooting with the camera in real time, photograph of the specimen surface damage and failure mode of the development process are taken. The results show that: when joint angle is constant, a greater joint space needs a greater penetration load when loading value drops, it also needs greater penetration power and crack propagation energy; when joint angle equals to 0 and 90, anti-invasive factor is consistent. When the joint angle equals to 30 and 60, with the increase of joint space, anti-invasive factor increases. When the joint spacing is constant, with the increase of the angle, the peak load, penetration power and crack propagation energy decrease and then increase. When joint angle equals to 30, the values are the minimum. According to a morphological analysis after the destruction of specimens, it is found that the spatial characteristics of joints crack obviously control the crack mode and have significant limitations for the damage region .

Key words: tunnel boring machine (TBM), disc cutter, joint parameter, penetration load

中图分类号:

TU 45

邹飞，李海波，周青春，莫振泽，朱小明，牛磊，杨风威 . 岩石节理倾角和间距对隧道掘进机破岩特性影响的试验研究[J]. , 2012, 33(6): 1640-1646.

ZOU Fei1, 2，LI Hai-bo ，ZHOU Qing-chun ，MO zhen-ze ，ZHU Xiao-ming ，NIU Lei ，YANG Feng-wei . Experimental study of influence of joint space and joint angle on rock fragmentation by TBM disc cutter[J]. , 2012, 33(6): 1640-1646.

参考文献

相关文章 15

[1]	刘鹤, 刘泉声, 唐旭海, 罗慈友, 万文恺, 陈磊, 潘玉丛, . TBM护盾−围岩相互作用荷载识别方法[J]. 岩土力学, 2019, 40(12): 4946-4954.
[2]	刘泉声，彭星新，黄兴，雷广峰，魏莱，刘鹤,. 全断面隧道掘进机护盾受力监测及卡机预警[J]. , 2018, 39(9): 3406-3414.
[3]	翟淑芳，周小平，毕靖, . TBM滚刀破岩的广义粒子动力学数值模拟[J]. , 2018, 39(7): 2699-2707.
[4]	刘泉声，赵怡凡，张晓平，孔晓璇. 灰岩隧道掘进机隧道点荷载试验评价岩石强度方法的研究与探讨[J]. , 2018, 39(3): 977-984.
[5]	陈卫忠，马池帅，田洪铭，杨建平,. TBM隧道施工期岩爆预测方法探讨[J]. , 2017, 38(S2): 241-249.
[6]	马池帅，陈卫忠，田洪铭，杨建平,. 基于TBM掘进参数的岩石强度估算方法探讨[J]. , 2017, 38(S2): 295-303.
[7]	刘泉声，刘琪，刘学伟，孙磊，张晓波，纪杰，. 楔刀作用下软硬互层岩体贯入破坏试验研究[J]. , 2017, 38(7): 1849-1855.
[8]	黄兴，刘泉声，彭星新，雷广峰，魏莱,. 引大济湟工程TBM挤压大变形卡机计算分析与综合防控[J]. , 2017, 38(10): 2962-2972.
[9]	冀佩琦，张晓平，张旗, . 延脆性变化对隧道掘进机刀具破岩过程及其破坏模式影响的颗粒元模拟分析[J]. , 2016, 37(S2): 724-734.
[10]	刘泉声，潘玉丛，孔晓璇，刘建平，时凯，崔先泽，黄诗冰,. TBM滚刀贯入过程中泥岩破坏特征试验研究[J]. , 2016, 37(S1): 166-174.
[11]	程建龙，杨圣奇，潘玉丛，田文岭，赵维生,. 挤压地层双护盾TBM围岩变形及应力场特征研究[J]. , 2016, 37(S1): 371-380.
[12]	肖亚勋，冯夏庭，陈炳瑞，丰光亮. 深埋隧洞即时型岩爆孕育过程的频谱演化特征[J]. , 2015, 36(4): 1127-1134.
[13]	谭青，李建芳，夏毅敏，徐孜军，朱逸，张佳 . 盘形滚刀破岩过程的数值研究[J]. , 2013, 34(9): 2707-2714.
[14]	莫振泽，李海波，周青春，邹飞，朱小明，王长柏，郝亚飞 . 楔刀作用下岩石微观劣化的试验研究[J]. , 2012, 33(5): 1333-1340.
[15]	莫振泽，李海波，周青春，何恩光，邹飞，朱小明，赵羽. 基于UDEC的隧道掘进机滚刀破岩数值模拟研究[J]. , 2012, 33(4): 1196-1202.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed