›› 2012, Vol. 33 ›› Issue (S2): 71-0076.

• 基础理论与实验研究 • 上一篇    下一篇

基于块体集上限分析的锚板试验模型探讨

余生兵1, 2,黄茂松1, 2   

  1. 1. 同济大学 地下建筑与工程系,上海 200092;2. 同济大学 岩土及地下工程教育部重点实验室,上海 200092
  • 收稿日期:2002-11-27 出版日期:2012-11-22 发布日期:2012-12-11
  • 作者简介:余生兵,男,1984年生,博士,主要从事岩土工程极限分析方法的研究
  • 基金资助:
    国家杰出青年科学基金项目资助(No. 50825803);上海市优秀学科带头人计划项目资助(No. 09XD1403900)

Discussion on test models of anchor plates based on block set mechanism

YU Sheng-bing 1, 2, HUANG Mao-song 1, 2   

  1. 1. Department of Geotechnical Engineering, Tongji University, Shanghai 200092, China; 2. Key Laboratory of Geotechnical and Underground Engineering of Ministry of Education, Tongji University, Shanghai 200092, China
  • Received:2002-11-27 Online:2012-11-22 Published:2012-12-11

摘要: 通过块体集上限分析方法,研究锚板的抗拔承载力和破坏面特性,并将分析结果与Das[1]以及Rowe[2]的锚板模型试验结果进行详细对比,验证块体集上限法的有效性。分析斜坡地形条件下锚板抗拔承载特性,并与Khing等[3]的条形锚板抗拔承载力试验以及Rao和Prasad[4]的圆形锚板抗拔承载力试验进行详细对比,分析斜坡地形条件下锚板模型试验中采用拉杆加载的方式对于试验结果的影响。分析结果表明,斜坡地形条件下拉杆的存在对于锚板抗拔承载力影响较大,模型试验应优先采用Trapdoor模型。

关键词: 极限分析, 块体集, 锚板, 抗拔承载力, 模型试验

Abstract: The block set mechanism was used to analyze the characters of pull-out capacity and failure surface of anchor plates. An application to upper bound analysis of vertically loaded strip anchors on horizontal ground surface is given first to illustrate the utility and effectiveness of the proposed method,and include detailed comparisons with model test results of Das[1] and Rowe[2]. Then analyses of anchor plates were given with emphasis on consideration of sloped ground. Comparisons between theoretical predictions of block set mechanism and model test results of Khing et al[3] and Rao and Prasad[4] are presented. The results show that the steel rod which adopted in model test as a loading device has a significant effect on pull-out capacity of anchor plates. So the Trapdoor model should be given priority in the model test of anchor plate which the sloped ground was taken into consideration.

Key words: limit analysis, block set, anchor plate, pull-out capacity, model test

中图分类号: 

  • TU 443
[1] 王国辉, 陈文化, 聂庆科, 陈军红, 范晖红, 张川, . 深厚淤泥质土中基坑开挖对基桩 影响的离心模型试验研究[J]. 岩土力学, 2020, 41(2): 399-407.
[2] 陈贺, 张玉芳, 张新民, 魏少伟, . 高压注浆钢花管微型桩抗滑特性 足尺模型试验研究[J]. 岩土力学, 2020, 41(2): 428-436.
[3] 孙来宾, 肖世国, . 抗滑桩受荷段前侧有限范围地层的 地基抗力系数取值方法[J]. 岩土力学, 2020, 41(1): 278-284.
[4] 戴国亮, 朱文波, 郭晶, 龚维明, 赵学亮, . 软黏土中吸力式沉箱基础竖向抗拔承载 特性试验研究[J]. 岩土力学, 2019, 40(S1): 119-126.
[5] 于一帆, 王平, 王会娟, 许书雅, 郭海涛, . 堆积层滑坡地震动力响应的物理模型试验[J]. 岩土力学, 2019, 40(S1): 172-180.
[6] 刘顺青, 黄献文, 周爱兆, 蔡国军, 姜朋明, . 基于随机块石模型的土石混合边坡稳定性 分析方法研究[J]. 岩土力学, 2019, 40(S1): 350-358.
[7] 雷华阳, 胡垚, 雷尚华, 祁子洋, 许英刚, . 增压式真空预压加固吹填超软土微观结构特征分析[J]. 岩土力学, 2019, 40(S1): 32-40.
[8] 王东坡, 陈政, 何思明, 陈克坚, 刘发明, 李明清, . 泥石流冲击桥墩动力相互作用物理模型试验[J]. 岩土力学, 2019, 40(9): 3363-3372.
[9] 陈宇龙, 内村太郎, . 基于弹性波波速的降雨型滑坡预警系统[J]. 岩土力学, 2019, 40(9): 3373-3386.
[10] 王钦科, 马建林, 陈文龙, 杨彦鑫, 胡中波, . 上覆土嵌岩扩底桩抗拔承载特性离心 模型试验及计算方法研究[J]. 岩土力学, 2019, 40(9): 3405-3415.
[11] 卢谅, 石通辉, 杨东, . 置换减载与加筋复合处理方法对路基不 均匀沉降控制效果研究[J]. 岩土力学, 2019, 40(9): 3474-3482.
[12] 杨文波, 邹涛, 涂玖林, 谷笑旭, 刘雨辰, 晏启祥, 何川. 高速列车振动荷载作用下马蹄形断面隧 道动力响应特性分析[J]. 岩土力学, 2019, 40(9): 3635-3644.
[13] 蔡雨, 徐林荣, 周德泉, 邓超, 冯晨曦, . 自平衡与传统静载试桩法模型试验研究[J]. 岩土力学, 2019, 40(8): 3011-3018.
[14] 孙飞, 张志强, 易志伟. 正断层黏滑错动对地铁隧道结构影响 的模型试验研究[J]. 岩土力学, 2019, 40(8): 3037-3044.
[15] 詹良通, 胡英涛, 刘小川, 陈捷, 王瀚霖, 朱斌, 陈云敏. 非饱和黄土地基降雨入渗离心模型试验 及多物理量联合监测[J]. 岩土力学, 2019, 40(7): 2478-2486.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 王观石,李长洪,陈保君,李世海. 应力波在非线性结构面介质中的传播规律[J]. , 2009, 30(12): 3747 -3752 .
[2] 刘远明,夏才初. 直剪条件下非贯通节理岩体岩桥力学性质弱化机制及贯通模型初步研究[J]. , 2010, 31(3): 695 -701 .
[3] 万少石,年廷凯,蒋景彩,栾茂田. 边坡稳定强度折减有限元分析中的若干问题讨论[J]. , 2010, 31(7): 2283 -2288 .
[4] 闫 铁,李 玮,毕雪亮. 基于分形方法的多孔介质有效应力模型研究[J]. , 2010, 31(8): 2625 -2629 .
[5] 刘振平,贺怀建,朱发华. 基于钻孔数据的三维可视化快速建模技术的研究[J]. , 2009, 30(S1): 260 -266 .
[6] 沈海超,程远方,赵益忠,张建国,夏元博. 靖边气田煤层地应力及井壁稳定研究[J]. , 2009, 30(S2): 123 -126 .
[7] 陈保国 ,孙金山 ,张 磊. 上埋式钢筋混凝土拱涵受力特性及地基处理研究[J]. , 2011, 32(5): 1500 -1506 .
[8] 王国粹,杨 敏. 砂土中水平受荷桩非线性分析[J]. , 2011, 32(S2): 261 -267 .
[9] 袁敬强 ,陈卫忠 ,谭贤君 ,王 辉. 软弱地层注浆的细观力学模拟研究[J]. , 2011, 32(S2): 653 -659 .
[10] 张 波 ,李术才 ,杨学英 ,张敦福 ,邵长利 ,杨为民 . 含交叉裂隙岩体相似材料试件力学性能单轴压缩试验[J]. , 2012, 33(12): 3674 -3679 .