节理分量式剪切本构模型及岩质边坡双安全系数研究

›› 2013, Vol. 34 ›› Issue (8): 2143-2150.

节理分量式剪切本构模型及岩质边坡双安全系数研究

宋东日，任伟中，黄诚，王安礼，张军

中国科学院武汉岩土力学研究所岩土力学与工程国家重点实验室，武汉 430071

收稿日期:2012-11-27 出版日期:2013-08-12 发布日期:2013-08-13
作者简介:宋东日，男，1987年生，硕士研究生，主要从事岩石力学与边坡稳定性研究方面工作
基金资助:
国家科技支撑计划项目资助（No. 2009BAK53B03）；国家重点基础研究发展计划（973）资助（No. 2010CB732101）；国家自然科学基金青年基金资助（No. 51008298）

Study of joint shearing component constitutive model and dual safety factors for jointed rock slope

SONG Dong-ri, REN Wei-zhong, HUANG Cheng, WANG An-li, ZHANG Jun

State Key Laboratory of Geomechanics and Geotechnical Engineering, Institute of Rock and Soil Mechanics, Chinese Academy of Sciences, Wuhan 430071, China

Received:2012-11-27 Online:2013-08-12 Published:2013-08-13

摘要/Abstract

摘要： 在法向荷载和切向荷载的作用下岩体节理的剪切应力由抗剪断效应、剪胀效应和摩擦效应所引起的三部分应力构成，但三个组成部分在节理的剪切过程中并不是同时发挥其最大作用。在详细分析边坡岩体节理工程地质特性的基础上，提出一种节理分量式剪切本构模型，主要特征为（1）体现了剪胀与剪切之间的耦合效应；（2）采用分量式表达，物理意义更明确；（3）每一分量采用简单函数，避免了总量式分段构造函数的不足。在节理分量式本构模型基础上，提出应用于岩质节理边坡的双安全系数的概念和求解原则，双安全系数能够较好地反映岩体节理剪切破坏直至残余强度的物理过程。最后，通过双安全系数算例明确了各个分量对于边坡稳定性的贡献。

关键词: 岩质边坡, 节理, 分量式本构模型, 剪胀, 双安全系数

Abstract: The shear stress of a rock joint is composed of three components triggered by anti-shear effect, dilatancy effect, and frictional effect under normal load and shear load; but the three components will not exert their maximum at the same point in the shear process of a rock joint. Firstly, the five main engineering geological properties of rock slope joints are analyzed in detail, which will provide engineering conditions for the component constitutive model. A component constitutive model of rock joints is presented and its characteristics are as follows: (1) The coupling effect between dilation and shearing is considered. (2) The component constitutive model has obvious physical meanings. (3) Each component is composed with a simple function, so segmental fitting functions are not needed. Furthermore, based on the component constitutive model of rock joints, the concept and solving principle of dual safety factors for jointed rock slope are put forward, which will directly show the physical process from shear failure to residual strength. The three components’ contribution to the slope stability is clarified by a calculation example.

Key words: rock slope, joint, component constitutive model, dilation, dual safety factors

中图分类号:

TU 452

宋东日，任伟中，黄诚，王安礼，张军. 节理分量式剪切本构模型及岩质边坡双安全系数研究[J]. , 2013, 34(8): 2143-2150.

SONG Dong-ri, REN Wei-zhong, HUANG Cheng, WANG An-li, ZHANG Jun. Study of joint shearing component constitutive model and dual safety factors for jointed rock slope[J]. , 2013, 34(8): 2143-2150.

参考文献

相关文章 15

[1]	王培涛, 黄正均, 任奋华, 章亮, 蔡美峰, . 基于3D打印的含复杂节理岩石直剪特性及破坏机制研究[J]. 岩土力学, 2020, 41(1): 46-56.
[2]	夏才初, 喻强锋, 钱鑫, 桂洋, 庄小清. 常法向刚度条件下岩石节理剪切−渗流特性试验研究[J]. 岩土力学, 2020, 41(1): 57-66.
[3]	张晨阳, 谌民, 胡明鉴, 王新志, 唐健健, . 细颗粒组分含量对钙质砂抗剪强度的影响[J]. 岩土力学, 2019, 40(S1): 195-202.
[4]	吴锦亮, 何吉, . 岩质边坡动态开挖模拟的复合单元模型[J]. 岩土力学, 2019, 40(S1): 535-540.
[5]	刘斯宏, 沈超敏, 毛航宇, 孙屹. 堆石料状态相关弹塑性本构模型[J]. 岩土力学, 2019, 40(8): 2891-2898.
[6]	刘新荣, 邓志云, 刘永权, 刘树林, 路雨明, . 地震作用下水平层状岩质边坡累积损伤与破坏模式研究[J]. 岩土力学, 2019, 40(7): 2507-2516.
[7]	言志信, 龙哲, 屈文瑞, 张森, 江平, . 地震作用下含软弱层岩体边坡锚固界面剪切作用分析[J]. 岩土力学, 2019, 40(7): 2882-2890.
[8]	李建朋, 高岭, 母焕胜. 高应力卸荷条件下砂岩扩容特征及其剪胀角函数[J]. 岩土力学, 2019, 40(6): 2119-2126.
[9]	何子露, 刘威, 何思明, 闫帅星, . 饱和松散堆积体快速滑动的剪胀效应机制与过程模拟[J]. 岩土力学, 2019, 40(6): 2389-2396.
[10]	朱仁杰, 车爱兰, 严飞, 文海, 葛修润, . 含贯通性结构面岩质边坡动力演化规律[J]. 岩土力学, 2019, 40(5): 1907-1915.
[11]	王凤云, 钱德玲, . 基于统一强度理论深埋圆形隧道围岩的剪胀分析[J]. 岩土力学, 2019, 40(5): 1966-1976.
[12]	周辉, 程广坦, 朱勇, 陈珺, 卢景景, 崔国建, 杨聘卿, . 大理岩规则齿形结构面剪切特性试验研究[J]. 岩土力学, 2019, 40(3): 852-860.
[13]	陆勇, 周国庆, 杨冬英, 宋家庆, . 砂土剪胀软化、剪缩硬化统一本构的显式计算[J]. 岩土力学, 2019, 40(3): 978-986.
[14]	高青鹏, 曹平, 王飞, 王柱. 压剪作用下多节理类岩试样力学性质及破坏判据[J]. 岩土力学, 2019, 40(3): 1013-1022.
[15]	徐栋栋, 邬爱清, 李聪, 汪斌, 蒋昱州, 曾平, 杨永涛, . 破裂全过程模拟的改进非连续变形分析方法[J]. 岩土力学, 2019, 40(3): 1169-1178.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed