IV级软弱围岩相似材料的试验研究

›› 2013, Vol. 34 ›› Issue (S1): 109-116.

IV级软弱围岩相似材料的试验研究

武伯弢^{1, 2, 4}，朱合华^{1, 2}，徐前卫^{1, 2, 3}，明娟⁵

1. 同济大学岩土及地下工程教育部重点实验室，上海 200092；2. 同济大学土木工程学院地下建筑与工程系，上海 200092； 3. 同济大学城市轨道与铁道工程系，上海200092；4. 越南水利科学研究院水工院，河内，越南； 4. 上海理工大学土木工程系，上海200093

收稿日期:2012-12-15 出版日期:2013-08-30 发布日期:2014-06-09
作者简介:武伯弢，男，1978年生，博士研究生，主要从事隧道围岩稳定性、地质力学物理模型试验、砂土液化及软土地基加固等领域的研究
基金资助:
国家自然科学基金资助（No.41130751）；西部交通建设科技项目资助 (No.2011ZB04)；同济大学岩土及地下工程教育部重点实验室开放实验基金资助（No.KLE- TJGE-B1108）

Experimental study of similar material for weak surrounding rock mass of class IV

WU Ba-tao^1,2,4 ZHU He-hua^1,2, XU Qian-wei^1,2,3, MING Juan⁵

1.Key Laboratory of Geotechnical and Underground Engineering of Ministry of Education, , Tongji University, Shanghai 200092, China; 2. Department of Geotechnical Engineering, College of Civil Engineering, Tongji University, Shanghai 200092, China; 3. Urban Rail Transit and Railway Engineering Department, Tongji University, Shanghai 200092, China; 4. Hydraulic Construction Institute, Vietnam Academy for Water Resources, Hanoi, Vietnam; 5. Department of Civil Engineering, University of Shanghai for Science and Technology, Shanghai 200093, China

Received:2012-12-15 Online:2013-08-30 Published:2014-06-09

摘要/Abstract

摘要： 以IV级围岩为参照对象，研制可用于隧道围岩稳定性物理模型试验的软弱围岩相似材料。采用的5种原材料（重晶石粉、石膏、细砂、洗衣液和水），通过直剪试验、无侧限抗压强度试验及三轴压缩试验测得所配相似材料的强度特征和物理力学参数，包括黏聚力c、内摩擦角?、单轴抗压强度Rc、弹性模量E和泊松比?。首先，通过试验分析每种原材料的不同比例对所配相似材料强度特征及物理力学参数的影响，选择适合于模拟IV级围岩相似材料的原材料配比；其次，针对优选的材料配比所配制的相似材料，开展大量的三轴压缩试验，研究在不同围压下该相似材料的强度及其破坏特征。结果表明，含水率减少或石膏含量增加导致Rc、E和c明显增大，而?降低不明显；增加砂含量可增大E 和?，但Rc值减少；石膏含量对相似材料的脆性和延性影响最明显，而含水率对相似材料的强度影响最为突出。试验结果还表明，相似材料在低围压时呈现脆性，在高围压时呈延性；就破坏准则而言，试验所得结果小于Mohr-Coulomb准则，略大于Hoek-Brown准则，但更符合Hoek-Brown准则。研制软岩相似材料的试验数据可为下一步拟开展的隧道围岩稳定性模型试验和数值模拟提供重要的参考和依据。

关键词: 软弱围岩, 相似材料, 物理模型试验, 破坏准则。

Abstract: This study aimed to develop an appropriate similar material for weak surrounding rock mass which can be used in physical model test of tunnel surrounding rock mass stability. The weak surrounding rock mass of class IV has been chosen as reference prototype for our research. Five raw materials, namely, barite powder, gypsum, fine sand, laundry detergent, and water were used to produce the similar material. Direct shear tests, uniaxial compression tests and triaxial compression tests were performed to obtain strength characteristics and physico-mechanical parameters of the material, including cohesive strength c, internal friction angle ? uniaxial compressive strength Rc, elastic modulus E, Poisson ratio ?. Firstly, a large number of the above mentioned tests were carried out to analyze the impact of various proportions of each raw material on strength characteristics and physico-mechanical parameters of the similar material; thus selecting appropriate raw material proportion to simulate the weak surrounding rock mass of class IV. Secondly, strength characteristics and failure behavior of the similar material which had been developed with selected raw material proportion, is further studied by a large numbers of triaxial compression tests under various confining pressures. The results indicate that, either decreasing water content or increasing gypsum content can lead to an obvious increase in Rc, E and c, along with a slight decrease in ?. On the other hand, the mounting of fine sand content resulted in an increase of E and ?, while Rc value decreased. In addition, while gypsum content turned out to be the most important factor affecting the brittle and ductile characteristics of similar material; water content affected the strength of such material significantly. The results also show that the developed material presents brittleness under low confining pressure, and becomes more ductile with the increase of confining pressure. Furthermore, failure data of the material are smaller than that calculated from linear Mohr-Coulomb failure criterion and slightly higher than that of nonlinear Hoek-Brown failure criterion. However, similar material obeys far better the Hoek-Brown criterion. The results of this study will be very useful for future research on tunnel surrounding rock mass stability in physical model tests, as well as in numerical simulations.

Key words: weak surrounding rock mass, similar material, physical model test, failure criterion

中图分类号:

TU 452

武伯弢，朱合华，徐前卫，明娟 . IV级软弱围岩相似材料的试验研究[J]. , 2013, 34(S1): 109-116.

WU Ba-tao ， ZHU He-hua , XU Qian-wei , MING Juan . Experimental study of similar material for weak surrounding rock mass of class IV[J]. , 2013, 34(S1): 109-116.

参考文献

相关文章 15

[1]	王东坡, 陈政, 何思明, 陈克坚, 刘发明, 李明清, . 泥石流冲击桥墩动力相互作用物理模型试验[J]. 岩土力学, 2019, 40(9): 3363-3372.
[2]	许江, 邬君宇, 刘义鑫, 雷娇, . 不同充填度下岩体剪切−渗流耦合试验研究[J]. 岩土力学, 2019, 40(9): 3416-3424.
[3]	储昭飞, 刘保国, 任大瑞, 宋宇, 马强, . 软岩流变相似材料的研制及物理模型试验应用[J]. 岩土力学, 2019, 40(6): 2172-2182.
[4]	马显春, 罗刚, 邓建辉, 上官力, . 陡倾滑面堆积层滑坡抗滑桩锚固深度研究[J]. 岩土力学, 2018, 39(S2): 157-168.
[5]	姚爱军，张剑涛，郭海峰，郭彦非. 地铁盾构隧道上方基坑开挖卸荷-加载影响研究[J]. , 2018, 39(7): 2318-2326.
[6]	刘金辉，李文枭，刘宇森，刘保国，. 多孔含水岩层的相似材料配比研究[J]. , 2018, 39(2): 657-664.
[7]	孙阳阳，王源，张清华，段建立，张文渊，章征林，由泽伟,. 模型相似材料内部应变光纤量测应变传递[J]. , 2018, 39(2): 759-764.
[8]	徐楚，胡新丽，何春灿，徐迎，周昌. 水库型滑坡模型试验相似材料的研制及应用[J]. , 2018, 39(11): 4287-4293.
[9]	汪北方，梁冰，王俊光，孙可明，孙维吉，迟海波，. 煤矿地下水库岩体碎胀特性试验研究[J]. , 2018, 39(11): 4086-4092.
[10]	岳哲，叶义成，王其虎，姚囝，施耀斌. 基于量纲分析的岩石相似材料抗压强度计算模型[J]. , 2018, 39(1): 216-221.
[11]	刘晓云，叶义成，王其虎，张华，刘艳章，刘洋，. 单轴压缩下不同强度组合复合岩体相似材料试件力学特性研究[J]. , 2017, 38(S2): 183-190.
[12]	王鹏，舒才，施峰，胡国忠，王宏图,. 不同砂胶比、密度和含水性相似材料力学性质正交试验研究[J]. , 2017, 38(S2): 229-235.
[13]	叶飞，宋京，唐勇三，林剑飞，贾涛，. 软弱围岩隧道掌子面及超前核心土挤出位移特征研究[J]. , 2017, 38(S1): 323-330.
[14]	田威，裴志茹，韩女. 基于CT扫描与3D打印技术的岩体三维重构及力学特性初探[J]. , 2017, 38(8): 2297-2305.
[15]	孟庆彬，韩立军，张帆舸，张建，聂军委，文圣勇，. 深部高应力软岩巷道耦合支护效应研究及应用[J]. , 2017, 38(5): 1424-1435.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed