低强度模拟锚固材料抗弯荷载-位移全过程曲线试验研究

›› 2013, Vol. 34 ›› Issue (S1): 228-233.

低强度模拟锚固材料抗弯荷载-位移全过程曲线试验研究

丁幸波^1,2，章冲³，明治清¹，徐景茂¹

1. 总参工程兵科研三所，河南洛阳 471023；2. 哈尔滨工业大学机电工程学院，哈尔滨 150001； 3. 河南科技大学计算机学院，河南洛阳 471023

收稿日期:2012-09-24 出版日期:2013-08-30 发布日期:2014-06-09
作者简介:丁幸波，男，1986年生，硕士，助理工程师，主要从事地质力学模型试验装置研究设计、模型试验工艺与试验技术研究

Experimental study of complete load-displacement curve of low strength analog anchoring material in bending process

DING Xing-bo^1,2，ZHANG Chong³，MING Zhi-qing¹，XU Jing-mao¹

1. The Third Engineer Scientific Research Institute of the Headquarters of the General Staff, Luoyang, Henan 471023, China; 2. School of Electrical and Mechanical, Harbin Institute of Technology, Harbin 150001, China； 3. School of Computer Science, Henan University of Science and Technology, Luoyang, Henan 471023, China

Received:2012-09-24 Online:2013-08-30 Published:2014-06-09

摘要/Abstract

摘要： 在大比例尺的地质力学模型中，由于相似模型材料的脆性和低强度，很难测得其抗弯应力-应变或者荷载-位移全过程曲线。对抗弯试验的过程进行力学分析，通过对增加辅助弹性元件方案的假设推导得到弹性元件刚度设计原则。依据该设计原则，组装出一台试验原理样机，测到不同节理（均质、层状和块状）含不同角度锚杆的试件的抗弯荷载-位移全过程曲线。此外，由于相似材料的低强度重度大特性，试验中适当考虑试件的自重对实验结果的影响。试验研究表明，弹性元件的增加对抗弯荷载-位移全过程曲线下降段有着质的改善；当弹性元件与台架的复合刚度大于试件的最大刚度，即可测得抗弯荷载-位移全过程曲线；在抗弯试验中试件自重荷载可以等效为集中力荷载，对于550 mm的标准试件其等效荷载相当于其自身重力1/2的集中荷载，相当于试验中均质试件峰值荷载的9%。

关键词: 低强度, 模拟锚固材料, 荷载-位移, 抗弯全过程, 刚度, 等效荷载

Abstract: In large-scale geomechanical model, because of the fragility and low strength of similar model material, it is difficult to get its complete bending stress-strain curve or load-displacement curve. This paper performed mechanical analysis on the bending experiment process, and got the stiffness designing principle of elastic element through some derivation for the solution of increasing the auxiliary elastic element.Based on this principle, we assembled a test prototype and obtained complete bending load-displacement curves for the specimens with different joints(homogeneous, layered and massive) containing different angles bolt. In addition, the dead weight of specimen was considered in the experiment due to the similar material's characteristics of low strength and bulk density. Experimental studies have shown that, the increasement of elastic element has a noteworthy improvement for the decreasing segment of the complete bending load-displacement curve. When the composite stiffness of the elastic element and prototype system is greater than the maximum stiffness of the specimen, the curve can be measured . The dead weight of specimen can be equivalent to the concentrated force in the bending experiment, and the equivalent load for the 550 mm long Standard specimen is 50% of its own weight or 9% of the peak load in homogeneous specimen’s experiment.

Key words: low strength, analog anchoring material, load-displacement curve, complete bending process, stiffness, equivalent load

中图分类号:

TH 69

丁幸波，章冲，明治清，徐景茂 . 低强度模拟锚固材料抗弯荷载-位移全过程曲线试验研究[J]. , 2013, 34(S1): 228-233.

DING Xing-bo ，ZHANG Chong ，MING Zhi-qing ，XU Jing-mao . Experimental study of complete load-displacement curve of low strength analog anchoring material in bending process[J]. , 2013, 34(S1): 228-233.

参考文献

相关文章 15

[1]	夏才初, 喻强锋, 钱鑫, 桂洋, 庄小清. 常法向刚度条件下岩石节理剪切−渗流特性试验研究[J]. 岩土力学, 2020, 41(1): 57-66.
[2]	芮圣洁, 国振, 王立忠, 周文杰, 李雨杰, . 钙质砂与钢界面循环剪切刚度与阻尼比的试验研究[J]. 岩土力学, 2020, 41(1): 78-86.
[3]	谢芸菲, 迟世春, 周雄雄, . 复杂环境中大规模桩筏基础的优化设计方法研究[J]. 岩土力学, 2019, 40(S1): 486-493.
[4]	张海廷, 杨林青, 郭芳, . 基于SBFEM的层状地基埋置管道动力响应求解与分析[J]. 岩土力学, 2019, 40(7): 2713-2722.
[5]	张治国, 张瑞, 黄茂松, 宫剑飞, . 基于差异沉降和轴向刚度控制的竖向荷载作用下群桩基础优化分析[J]. 岩土力学, 2019, 40(6): 2354-2368.
[6]	周辉, 程广坦, 朱勇, 陈珺, 卢景景, 崔国建, 杨聘卿, . 大理岩规则齿形结构面剪切特性试验研究[J]. 岩土力学, 2019, 40(3): 852-860.
[7]	崔春义, 孟坤, 武亚军, 马科研, 梁志孟, . 轴对称径向非均质土中单桩纵向振动特性研究[J]. 岩土力学, 2019, 40(2): 570-579.
[8]	周雄雄, 迟世春, 贾宇峰, 谢芸菲, . 高土石坝填筑过程的精细化模拟方法[J]. 岩土力学, 2018, 39(S2): 443-450.
[9]	徐平, 翟攀攀, 张天航, 董新平. 盾构隧道衬砌管片接头弯曲刚度类指数模型研究[J]. 岩土力学, 2018, 39(S2): 83-90.
[10]	肖国峰，陈从新. 岩质块体渐进破坏的稳定分析方法[J]. , 2018, 39(8): 3001-3010.
[11]	刘飞禹，施静，王军，蔡袁强,. 三明治形加筋土筋-土界面动力剪切特性[J]. , 2018, 39(6): 1991-1998.
[12]	王观石，熊鹏，胡世丽，孟世明，龙平，谭谈，. 位移不连续模型在黏弹性节理刚度计算的应用[J]. , 2018, 39(6): 2175-2183.
[13]	刘林超，肖琪聃，闫启方. 基于土体三维波动模型的饱和土中管桩竖向振动[J]. , 2018, 39(5): 1720-1730.
[14]	林清辉，严佳佳，董梅，朱剑锋，. 大主应力方向及中主应力系数对重塑黄土小应变刚度特性影响试验研究[J]. , 2018, 39(4): 1369-1376.
[15]	崔强, 程永锋, 鲁先龙, 谢枫, 孙付涛, . 强风化岩中挖孔基础抗拔试验及荷载位移曲线模型参数研究[J]. 岩土力学, 2018, 39(12): 4597-4604.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed