›› 2015, Vol. 36 ›› Issue (S2): 95-103.doi: 10.16285/j.rsm.2015.S2.012

• 基础理论与实验研究 • 上一篇    下一篇

粗粒料多边形表征及二维FEM/DEM分析

严成增1, 2,郑 宏2,孙冠华2,葛修润2   

  1. 1. 北京工业大学 建筑工程学院,北京 100124;2. 中国科学院武汉岩土力学研究所 岩土力学与工程国家重点实验室,湖北 武汉 430071
  • 收稿日期:2014-12-23 出版日期:2015-08-31 发布日期:2018-06-14
  • 作者简介:严成增,男,1986年生,博士,主要从事离散元有限元耦合、离散元、颗粒物质物理与力学、多物理场耦合、DDA、高性能并行计算及软件工程。
  • 基金资助:
    国家重点基础研究发展计划(973)(No.2011CB013505,No.2014CB047100); 国家自然科学青年基金(No.11202223)。

Polygon characterization of coarse aggregate and two-dimensional combined finite discrete element method analysis

YAN Cheng-zeng1, 2, ZHENG Hong2, SUN Guan-hua2, GE Xiu-run2   

  1. 1. College of Architecture and Civil Engineering, Beijing University of Technology, Beijing 100124, China; 2. State Key Laboratory of Geomechanics and Geotechnical Engineering, Institute of Rock and Soil Mechanics, Chinese Academy of Sciences, Wuhan, Hubei 430071, China
  • Received:2014-12-23 Online:2015-08-31 Published:2018-06-14

摘要: 考虑到颗粒形状对粗粒料的力学特性有重大影响,提出了一种新的表征颗粒形状的方法,即在椭圆上随机选取一系列点连接成多边形颗粒,表征狭长扁平的颗粒。新方法较圆上取点的方法能代表更多类型的颗粒形状,适用范围更广。提出了一种新的粗粒料投放算法,即先缩小颗粒,然采用随机算法将缩小的颗粒投放至给定区域,对颗粒划分好网格后,将颗粒放大到原来的大小,然后采用有限元-离散元(FEM/DEM)方法计算稳定后即生成了相应的试样。通过将上述颗粒生成及投放算法与FEM/DEM结合,应用于粗粒料的数值模拟。分析表明,FEM/DEM是研究粗粒料力学性质的较好方法,对复杂的颗粒形状也可简单建模,且因在颗粒内部划分了有限元网格,复杂的接触判断及接触力计算转化为标准统一的三角形和三角形之间的接触判断及接触力计算,所有的计算均可标准化、统一化。同时因为颗粒是可以变形的,依然保留了连续介质力学中应力和应变的概念,无须像PFC那样需通过测量圆来间接表示某点的应力、应变。最后,通过粗粒料的侧限压缩试验的数值模拟,展现了文中提出的一整套解决方案在模拟粗粒料方面的巨大潜力。

关键词: 有限元-离散元, 粗粒料, 颗粒投放, 多边形颗粒

Abstract: Considering that the shapes of particles have an important impact on the mechanical properties of the coarse aggregate, this paper proposes a new method for characterizing particle shapes. The method randomly selects a series of points on ellipse; then those points are connected to form polygon particles. The new method can represent more types of particle shapes than old method that access points on the circle, applies more broadly, can characterize the narrow flat particles. In addition, a new algorithm of particle delivery is proposed, which is to reduce the particle; then the reduced particles are put to the given area randomly. After the particle was meshed by triangular element, the reduced particles was enlarge to the original size. Afterwards, using finite combined finite-discrete element method(FEM/DEM) to calculating equilibrium state, a sample that meet given void ratio was generated. Then the particle generation algorithm above and FEM/DEM was combined, the FEM/DEM method is applied to coarse aggregate numerical simulation, the analysis shows, FEM/DEM is a great way to study the mechanical properties of coarse aggregate. The complex particle shape can also be modeling simply, because the particles was meshed into the triangle finite element, complex contact judgments and the contact force calculation can be transformed into a standard uniform contact judgments and contact force calculations between triangles, all calculations can be standardization and unification. At the same time, particles can be deformed, the concept of stress and strain that belong to the continuum mechanics was still retains, rather than PFC which stress and strain of a point was expressed indirectly by the measuring circle. Finally, by confined compression test numerical simulations of coarse aggregate show enormous potential of the proposed set of solutions in the simulation coarse aggregate.

Key words: finite element method/discrete element method(FEM/DEM), coarse grained materials, particle delivery, polygon particles

中图分类号: 

  • O 319.56
[1] 吴二鲁, 朱俊高, 郭万里, 陆阳洋. 基于级配方程的粗粒料压实特性试验研究[J]. 岩土力学, 2020, 41(1): 214-220.
[2] 孙逸飞,沈 扬,刘汉龙,. 粗粒土的分数阶应变率及其与分形维度的关系[J]. , 2018, 39(S1): 297-302.
[3] 孙逸飞,沈 扬. 基于分数阶微积分的粗粒料静动力边界面本构模型[J]. , 2018, 39(4): 1219-1226.
[4] 姜景山,程展林,左永振,丁红顺,. 干密度对粗粒料力学特性的影响[J]. , 2018, 39(2): 507-514.
[5] 姜景山,程展林,左永振,丁红顺,. 三维应力状态下粗粒料强度特性试验研究[J]. , 2018, 39(10): 3581-3588.
[6] 郭万里,朱俊高,余 挺,金 伟,. 土的连续级配方程在粗粒料中的应用[J]. , 2018, 39(10): 3661-3667.
[7] 姜景山,程展林,左永振,丁红顺,. 材料状态对粗粒料力学特性影响的试验研究[J]. , 2017, 38(S2): 131-137.
[8] 武利强,朱 晟,章晓桦,陈文亮,. 粗粒料试验缩尺效应的分析研究[J]. , 2016, 37(8): 2187-2197.
[9] 赵 娜,左永振,王占彬,余盛关. 基于分形理论的粗粒料级配缩尺方法研究[J]. , 2016, 37(12): 3513-3519.
[10] 严成增 ,郑 宏 ,孙冠华 ,葛修润,. 基于FDEM-Flow研究地应力对水力压裂的影响[J]. , 2016, 37(1): 237-246.
[11] 左永振,张 伟,潘家军,赵 娜. 粗粒料级配缩尺方法对其最大干密度的影响研究[J]. , 2015, 36(S1): 417-422.
[12] 杨 贵 ,许建宝 ,刘昆林 , . 粗粒料颗粒破碎数值模拟研究[J]. , 2015, 36(11): 3301-3306.
[13] 秦尚林 ,杨兰强 ,高 惠 ,陈善雄,. 不同应力路径下绢云母片岩粗粒料声发射特征[J]. , 2015, 36(1): 89-96.
[14] 严成增,郑 宏,葛修润. 基于统一标定的势接触力计算[J]. , 2015, 36(1): 249-256.
[15] 严成增,郑 宏,孙冠华,葛修润. 基于OpenMP的二维有限元-离散元并行分析方法[J]. , 2014, 35(9): 2717-2724.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 吴 琼,唐辉明,王亮清,林志红. 库水位升降联合降雨作用下库岸边坡中的浸润线研究[J]. , 2009, 30(10): 3025 -3031 .
[2] 吴昌瑜,张 伟,李思慎,朱国胜. 减压井机械淤堵机制与防治方法试验研究[J]. , 2009, 30(10): 3181 -3187 .
[3] 陈红江,李夕兵,刘爱华. 矿井突水水源判别的多组逐步Bayes判别方法研究[J]. , 2009, 30(12): 3655 -3659 .
[4] 和法国,谌文武,韩文峰,张景科. 高分子材料SH固沙性能与微结构相关性研究[J]. , 2009, 30(12): 3803 -3807 .
[5] 雷永生. 西安地铁二号线下穿城墙及钟楼保护措施研究[J]. , 2010, 31(1): 223 -228 .
[6] 肖 忠,王元战,及春宁,黄泰坤,单 旭. 波浪作用下加固软基上大圆筒结构稳定性分析[J]. , 2010, 31(8): 2648 -2654 .
[7] 柴 波,殷坤龙,陈丽霞,李远耀. 岩体结构控制下的斜坡变形特征[J]. , 2009, 30(2): 521 -525 .
[8] 赵洪波,茹忠亮,张士科. SVM在地下工程可靠性分析中的应用[J]. , 2009, 30(2): 526 -530 .
[9] 徐 扬,高 谦,李 欣,李俊华,贾云喜. 土石混合体渗透性现场试坑试验研究[J]. , 2009, 30(3): 855 -858 .
[10] 章定文,刘松玉,顾沉颖. 各向异性初始应力状态下圆柱孔扩张理论弹塑性分析[J]. , 2009, 30(6): 1631 -1634 .