›› 2018, Vol. 39 ›› Issue (10): 3581-3588.doi: 10.16285/j.rsm.2017.0234

• 基础理论与实验研究 • 上一篇    下一篇

三维应力状态下粗粒料强度特性试验研究

姜景山1, 2,程展林2,左永振2,丁红顺2   

  1. 1. 南京工程学院 建筑工程学院,江苏 南京 211167;2. 长江科学院 水利部岩土力学与工程重点实验室,湖北 武汉 430010
  • 收稿日期:2017-05-14 出版日期:2018-10-11 发布日期:2018-11-04
  • 作者简介:姜景山,男,1978年生,博士,副教授,主要从事粗粒土力学性质、地基和路基处理等方面的研究工作。
  • 基金资助:
    长江科学院开放研究基金资助项目(No. CKWV2017510/KY);国家自然科学基金面上项目(No. 51679072, No. 51379021, No. 51778282);南京工程学院校级科研基金项目资助(No. CKJB201706)。

Experimental investigation on strength characteristic of coarse-grained materials in three-dimensional stress state

JIANG Jing-shan1, 2, CHENG Zhan-lin2, ZUO Yong-zhen2, DING Hong-shun2   

  1. 1. School of Architectural Engineering, Nanjing Institute of Technology, Nanjing, Jiangsu 211167, China; 2. Key Laboratory of Geotechnical Mechanics and Engineering of Ministry of Water Resources, Changjiang River Scientific Research Institute, Wuhan, Hubei 430010, China
  • Received:2017-05-14 Online:2018-10-11 Published:2018-11-04
  • Supported by:
    This work was supported by the CRSRI Open Research Program (CKWV2017510/KY), the General Program of National Natural Science Foundation of China (51679072, 51379021, 51778282) and the Scientific Research Foundation of Nanjing Institute of Technology (CKJB201706).

摘要: 粗粒料所处的应力状态具有随时间和空间而变的特点,往往处于较复杂的三维应力状态下。通过粗粒料大型真三轴各向等压固结等比例加载试验,研究了不同中主应力系数条件下粗粒料的强度特性。试验结果表明:中主应力对粗粒料的强度有重要影响,三维应力状态下,粗粒料的强度比常规三轴应力状态下有较大提高,大小主应力之差与大主应变关系曲线也更加陡峭;中主应力系数b从0增大到0.25时,破坏时大小主应力之差增加了39%~50%;摩尔–库仑强度参数咬合力c和内摩擦角? 均随着中主应力系数b的增大而增大,其中咬合力c的增长较为显著,特别是b从0增大到0.25时;相同小主应力条件下,b = 0时,破坏偏应力与球应力之比最小,b = 0.25时,破坏应力比达到最大值,随着b的增大破坏应力比又有所减小;相同中主应力系数条件下,随着小主应力的增大,破坏应力比逐渐减小。

关键词: 粗粒料;三维应力状态;大型真三轴试验;中主应力;强度特性;破坏应力比;应力&ndash, 应变关系

Abstract: The coarse-grained materials are normally in three-dimensional (3D) stress state which changes with time and location. To investigate the strength characteristic of coarse-grained materials at different coefficients of intermediate principal stress, large-scale true triaxial tests were performed under isotropic consolidation and proportional loading conditions. The results show that the intermediate principal stress has an important effect on the strength of coarse-grained materials. The strength of coarse-grained materials in 3D stress state increases greatly compared to the strength in conventional triaxial stress state. The relationship of the major principal strain and the difference between the maximum and the minimum principal stresses in 3D stress state is steeper than that in conventional triaxial stress state. The difference between the maximum and the minimum principal stresses increases from 39% to 50% when the coefficient of intermediate principal stress increases from 0 to 0.25. Both the interlocking force c and internal friction angle ? increase with the increase of the coefficient of intermediate principal stress b. Especially, the interlocking force c increases significantly when b increases from 0 to 0.25. With the same minimum principal stress, the ratio of deviatoric stress to spheric stress at the failure state is the smallest with b=0, whereas the failure stress ratio reaches the maximum with b=0.25. However, the failure stress ratio decreases with the increase of b from 0.25 to 0.75. The stress ratio at failure state decreases with the increase of the minimum principal stress at the same coefficient of intermediate principal stress.

Key words: coarse-grained materials, three-dimensional stress state, large-scale true triaxial test, intermediate principal stress, strength behaviour, stress ratio at failure state, stress-strain relationship

中图分类号: 

  • TU 411
[1] 刘红岩. 宏细观缺陷对岩体力学特性及边坡稳定影响研究[J]. 岩土力学, 2019, 40(S1): 431-439.
[2] 马秋峰, 秦跃平, 周天白, 杨小彬. 多孔隙岩石加卸载力学特性及本构模型研究[J]. 岩土力学, 2019, 40(7): 2673-2685.
[3] 李修磊, 李金凤, 施建勇, . 考虑纤维加筋作用的城市生活 垃圾土弹塑性本构模型[J]. 岩土力学, 2019, 40(5): 1916-1924.
[4] 胡田飞, 刘建坤, 王天亮, 岳祖润, . 粉质黏土变形特性的冻融循环效应及其双屈 服面本构模型[J]. 岩土力学, 2019, 40(3): 987-997.
[5] 谷建晓, 杨钧岩, 王勇, 吕海波, . 基于南水模型的钙质砂应力−应变关系模拟[J]. 岩土力学, 2019, 40(12): 4597-4606.
[6] 崔凯, 冯飞, 谌文武, 汪小海, 程富强, . 生石灰为掺料的土遗址裂隙注浆浆液结石体 力学兼容性研究[J]. 岩土力学, 2019, 40(12): 4627-4636.
[7] 吉恩跃, 陈生水, 傅中志, . 掺砾心墙料拉裂力学特性试验研究[J]. 岩土力学, 2019, 40(12): 4777-4782.
[8] 曾志雄,孔令伟,李晶晶,李聚昭, . 干湿-冻融循环下延吉膨胀岩的力学特性及其应力-应变归一化[J]. , 2018, 39(8): 2895-2904.
[9] 姜景山,程展林,左永振,丁红顺,. 干密度对粗粒料力学特性的影响[J]. , 2018, 39(2): 507-514.
[10] 刘寒冰,张互助,王 静,. 冻融及含水率对压实黏质土力学性质的影响[J]. , 2018, 39(1): 158-164.
[11] 张 玉,何 晖,赵 敏,李宝平,丁 潇. 平面应变条件下原状黄土侧向卸载变形与强度特性分析[J]. , 2017, 38(5): 1233-1242.
[12] 林呈祥,凌道盛,钟世英, . 模拟月壤抗剪强度试验研究及离散元分析[J]. , 2017, 38(3): 893-901.
[13] 黄茂松,李 森,俞 剑, . 水平受荷桩的弹性有限元虚拟加载上限分析[J]. , 2016, 37(8): 2399-2403.
[14] 何明明 ,李 宁 ,朱才辉 ,陈蕴生,. 岩石分数阶体积变形模型及其试验研究[J]. , 2016, 37(11): 3137-3144.
[15] 刘方成,张永富,任东滨. 橡胶砂应力-应变特性三轴-单剪联合试验研究[J]. , 2016, 37(10): 2769-2779.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!