›› 2015, Vol. 36 ›› Issue (S2): 595-602.doi: 10.16285/j.rsm.2015.S2.084

• 岩土工程研究 • 上一篇    下一篇

点荷载强度指数估算与岩浆岩的单轴压缩强度的关系

张建明,唐志成,刘泉声   

  1. 武汉大学 土木建筑工程学院,湖北 武汉 430072
  • 收稿日期:2014-07-29 出版日期:2015-08-31 发布日期:2018-06-14
  • 作者简介:张建明,男,1990年生,硕士研究生,主要从事岩石力学及TBM破岩机理方面的研究工作。
  • 基金资助:
    国家自然科学青年基金(No.41402247);国家重点基础研究发展计划(973项目)(No.2014CB046904);湖北省自然科学基金重点项目(创新群体)(No.2011CDA119);中国博士后科学基金资助项目(No.2014M550407)。

Relation between point load index and uniaxial compressive strength for igneous rock

ZHANG Jian-ming, TANG Zhi-cheng, LIU Quan-sheng   

  1. School of Civil and Architectural Engineering, Wuhan University, Wuhan, Hubei 430072, China
  • Received:2014-07-29 Online:2015-08-31 Published:2018-06-14

摘要: 单轴压缩强度是岩石工程建设中广泛使用的力学参数,直接确定单轴压缩强度相对耗时且较为麻烦。点荷载试验可以间接估算岩石的单轴压缩强度(UCS),试验方式简洁。通过收集到的岩浆岩点荷载试验成果,分析结果表明,(1)大部分转换公式在点荷载强度指数较大时得到偏高的单轴压缩强度值,特别是对部分幂函数;(2)ISRM(American Society for Testing and Materials)建议的取值范围仍然高估了岩石的单轴压缩强度值。为更准确地估算岩石的单轴压缩强度,建议采用点荷载强度指数 的二次函数(见式(1))估算岩石的单轴压缩强度,适用范围为0.0 MPa < <15.0 MPa。

关键词: 岩浆岩, 点荷载强度, 单轴压缩强度

Abstract: The uniaxial compressive strength(UCS) of rocks is the crucial parameter in the design stage of rock engineering. Direct determination of the parameter is expensive, time-consuming and troublesome. The most widely used indirect determination method to predict the UCS is the point load test. Based on detailed analysis of the available experimental data of igneous rock published on the international journal, the shortcomings of the existed empirical equations are as follows: (1) Most of the equations overestimate the UCS with increasing point load strength index , especially for the power function. (2) The lower limit boundary suggested by ISRM (American Society for testing and Materials) still overestimates the UCS. To assess the UCS of rock in a between way, a new empirical parabolic equation eq. (1) is suggested and the application scope is 0.0 MPa < <15.0 MPa.

Key words: igneous rock, point load strength, uniaxial compressive strength

中图分类号: 

  • TU 452
[1] 田军, 卢高明, 冯夏庭, 李元辉, 张希巍. 主要造岩矿物微波敏感性试验研究[J]. 岩土力学, 2019, 40(6): 2066-2074.
[2] 付 伟,汪 稔,胡明鉴,向焱红. 不同温度下冻土单轴抗压强度与电阻率关系研究[J]. , 2009, 30(1): 73-78.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 陶干强,杨仕教,任凤玉. 崩落矿岩散粒体流动性能试验研究[J]. , 2009, 30(10): 2950 -2954 .
[2] 宫伟力,安里千,赵海燕,毛灵涛. 基于图像描述的煤岩裂隙CT图像多尺度特征[J]. , 2010, 31(2): 371 -376 .
[3] 万 智,董 辉,刘宝琛. 基于正交设计下SVM滑坡变形时序回归预测的超参数选择[J]. , 2010, 31(2): 503 -508 .
[4] 孙曦源,栾茂田,唐小微. 饱和软黏土地基中桶形基础水平承载力研究[J]. , 2010, 31(2): 667 -672 .
[5] 王明年,郭 军,罗禄森,喻 渝,杨建民,谭忠盛. 高速铁路大断面黄土隧道深浅埋分界深度研究[J]. , 2010, 31(4): 1157 -1162 .
[6] 胡勇刚,罗 强,张 良,黄 晶,陈亚美. 基于离心模型试验的水泥土搅拌法加固斜坡软弱土地基变形特性分析[J]. , 2010, 31(7): 2207 -2213 .
[7] 谭峰屹,姜志全,李仲秋,颜惠和. 附加质量法在昆明新机场填料压实密度检测中的应用研究[J]. , 2010, 31(7): 2214 -2218 .
[8] 柴 波,殷坤龙,肖拥军. 巴东新城区库岸斜坡软弱带特征[J]. , 2010, 31(8): 2501 -2506 .
[9] 王光进,杨春和,张 超,马洪岭,孔祥云,侯克鹏. 超高排土场的粒径分级及其边坡稳定性分析研究[J]. , 2011, 32(3): 905 -913 .
[10] 胡海军,蒋明镜,赵 涛,彭建兵,李 红. 制样方法对重塑黄土单轴抗拉强度影响的初探[J]. , 2009, 30(S2): 196 -199 .