›› 2016, Vol. 37 ›› Issue (7): 2033-2039.doi: 10.16285/j.rsm.2016.07.026

• 岩土工程研究 • 上一篇    下一篇

基于断裂力学的特厚煤层综放开采顶板破断规律研究

杨登峰1，张凌凡1，柴 茂1，李 博1，白翼飞2   

  1. 1.中国矿业大学(北京) 力学与建筑工程学院，北京 100083；2. 泰山职业技术学院 建筑工程系，山东 泰安 271000
  • 收稿日期:2015-12-18 出版日期:2016-07-11 发布日期:2018-06-09
  • 作者简介:杨登峰，男，1985年生，博士，主要从事矿山压力与支架-围岩关系方面的研究工作
  • 基金资助:

    国家重点基础研究发展规划(973)项目(No. 2013CB227903)；国家自然科学基金项目(No. 51174208, No. U1361209, No.51234005)。

Study of roof breaking law of fully mechanized top coal caving mining in ultra-thick coal seam based on fracture mechanics

YANG Deng-feng1，ZHANG Lin-fan1，CHAI Mao1，LI Bo1，BAI Yi-fei2   

  1. 1. School of Mechanics & Civil Engineering, China University of Mining & Technology, Beijing 100083, China; 2. Department of Architecture and Civil Engineering, Taishan Polytechnic, Taian, Shandong 271000, China
  • Received:2015-12-18 Online:2016-07-11 Published:2018-06-09
  • Supported by:

    This work was supported by the National Development Scheme of Key Fundamental Research of China (2013CB227903) and National Natural Science Foundation of China (51174208, U1361209, 51234005).

PDF (Chinese)

951

摘要： 针对特厚煤层综放开采过程中矿压显现剧烈支架工作阻力难以确定的问题，结合特厚煤层工作面顶板岩层破断形成的悬臂梁-砌体梁力学结构模型。工作面来压阶段支架工作阻力不足时，引起砌体梁结构下沉使悬臂梁结构回转变形破断，造成上覆砌体梁结构滑落失稳压架使工作面矿压显现剧烈的特点，建立了含中心斜裂纹的悬臂梁结构破断的力学模型，应用断裂力学理论，分析了悬臂梁破断失稳的影响因素，推导了支架荷载的表达式。结果表明：裂纹倾角和长度是悬臂梁破断失稳的主要影响因素；支架荷载除与悬臂梁自身因素有关外，还与砌体梁垮落步距等因素相关。结合塔山煤矿8102综采工作面地质条件，计算了支架荷载的理论值，验证了理论分析的合理性。理论研究成果对于分析特厚煤层开采时的支架荷载的大小，合理选择支架减少顶板事故具有一定的工程实际意义。

关键词: 特厚煤层, 综放开采, 悬臂梁-砌体梁结构, 斜裂纹, 支架工作阻力

Abstract: To solve the problems of the sharply appeared mine pressure and determination of the support working resistance in mechanized caving mining process of the ultra-thick coal seam, a structural model of cantilever beam-masonry beam is considered. When the support resistance is low at the time of face pressing, the subsidence of masonry beam results in the rotational deformation and the failure of cantilever beam. Furthermore, it leads to the slide breaking and pressing frame of the cantilever beam and the violent behavior of mine pressure. A mechanical model of breaking cantilever beam structure with a central crack is thus established. The effect of a serious of factors on the failure of the cantilever beam is analyzed by using fracture mechanics theory, and the expression of the support load is derived. The results show that the angle and length of the crack are the main factors influencing the failure of the cantilever beam. In addition, the support load is also relevant to other factors such as the falling step distance of the masonry beam. Based on the geological conditions of the fully mechanized working face 8102 in Tashan mine, the calculated support loads are used to verify the theoretical analysis. The results are of practical significance for analyzing the support load of ultra-thick coal seam mining and for providing reasonable selection of support to reduce the roof accident.

Key words: ultra-thick coal seam, fully mechanized caving mining, structure of cantilever beam-masonry beam, oblique crack, support working resistance

中图分类号: 

  • TD 324

[1] 刘 畅，刘正和，张俊文，杨增强，蔡震川，李玉琳,. 工作面长度对覆岩空间结构演化及大采高采场矿压规律的影响[J]. , 2018, 39(2): 691-698.
[2] 汪北方，梁 冰，孙可明，武占超，孙维吉，姜利国，王俊光,. 典型浅埋煤层长壁开采覆岩采动响应与控制研究[J]. , 2017, 38(9): 2693-2700.
[3] 何 团，毛德兵，黄志增，孙晓冬，张学亮, . 特厚煤层区段防水煤柱稳定性评价及保护技术研究[J]. , 2017, 38(4): 1148-1153.
[4] 常聚才，谢广祥，张学会. 特厚煤层大采高综放工作面煤壁片帮机制分析[J]. , 2015, 36(3): 803-808.
[5] 彭林军 ，张东峰 ，郭志飚 ，段庆伟，. 特厚煤层小煤柱沿空掘巷数值分析及应用[J]. , 2013, 34(12): 3609-3616.
[6] 刘 贵 ，刘治国 ，张华兴 ，尹润生. 泾河下综放开采隔离煤柱对覆岩破坏控制作用的物理模拟[J]. , 2011, 32(S1): 433-0437.
Viewed
Full text


Abstract

Cited
  Shared   
  Discussed   
No Suggested Reading articles found!
版权所有 © 《岩土力学》编辑部
地址：湖北武汉武昌小洪山中国科学院武汉岩土力学研究所(430071)　邮编：200042　电话：027-87198484, 87199252, 87199253, 87198752　E-mail: ytlx@whrsm.ac.cn
本系统由北京玛格泰克科技发展有限公司设计开发