›› 2005, Vol. 26 ›› Issue (S1): 193-197.

• 基础理论与实验研究 • 上一篇    下一篇

近海码头大圆筒基床夹泥的砂砾挤扩灌浆桩加固法

何开胜1,童旭东2,周荣官1,汪成明3   

  1. 1.南京水利科学研究院,南京 210029;2.中交水运规划设计院,北京 100007;3.海南民生燃气股份有限公司,海口 570208
  • 收稿日期:2005-02-24 发布日期:2005-12-15
  • 作者简介:何开胜,男,1963年生,博士,教授级高级工程师,从事软土地基处理、防灾减灾和土工数值分析研究。

Extruded sand-gravel column with sleeve valve grouting to remedy the slant of large diameter cylinder piers on the sea due to mud interlayer within foundation

HE Kai-sheng1, TONG Xu-dong2, ZHOU Rong-guan1, WANG Cheng-ming   

  1. 1.Geotechnical Department, Nanjing Hydraulic Research Institute, Nanjing 210024, China; 2.China Communications Planning and Designing Institute for Water Transportation, Beijing 100007, China; 3. Hainan Minsheng Gas Corporation, Haikou 570208, China
  • Received:2005-02-24 Published:2005-12-15

摘要: 针对长流油气码头海上重达千吨以上的大圆筒码头基床夹泥引起倾斜的工程问题,研究提出了砂砾挤扩灌浆桩的 加固新方法,并进行了加固设计、现场施工和质量检测。检测结果表明,挤入淤泥和粉土中的纯砂砾柱平均直径达到55~ 82 cm,28 d龄期时水泥砂砾灌浆体取芯的抗压强度达到4.3~11.4 MPa。工程竣工使用1年状态良好,表明砂砾挤扩灌浆桩的提出和应用取得圆满成功。

关键词: 码头, 大圆筒, 抛石基床, 砂砾挤扩灌浆桩

Abstract: For the slant problem of large diameter cylinder piers on the sea due to remained mud interlayer between the enrockment bedding and bedrock, a new remedy method is put forward and designed. It is extruded sand-gravel column with sleeve valve grouting, formed by pouring sand-gravel into boring hole, aiguille extruding them into the soft clay interlayer and enrockment, then grouting with sleeve valve. The inspection results after construction indicate that the diameter of pure sand-gravel column in mud and silt reaches 55 to 82 cm, the boring core sample strength of grouting column reaches 4.3 to 11.4 MPa at 28 days. Now the remedy project is completed for 1 year, the good state of large diameter piers shows that the suggested method is very successful.

Key words: wharf, large diameter cylinder pier, enrockment bedding, extruded sand-gravel column with sleeve valve grouting

中图分类号: 

  • TU 43
[1] 孙熙平,张 勇,郑锋勇,齐广政. 高桩码头基桩竖向承载力原型试验研究[J]. , 2014, 35(9): 2609-2615.
[2] 王元战 ,贺林林 ,王朝阳,. 离岸深水全直桩码头动力简化计算方法研究[J]. , 2014, 35(10): 2969-2976.
[3] 叶 锋,童新春,张功新,张宝洁,刘元立. 重锤夯实抛石基床的有效加固深度试验研究[J]. , 2011, 32(4): 1008-1012.
[4] 王丽艳 ,陈香香 ,刘汉龙. 液化地基中沉箱码头墙体地震残余变形的有效动应力研究[J]. , 2011, 32(11): 3361-3367.
[5] 徐光明,蔡正银,曾友金,顾行文,李士林,刘永绣,吴荔丹. 一种新型板桩码头结构的离心模拟[J]. , 2010, 31(S1): 48-52.
[6] 肖 忠,王元战,及春宁,黄泰坤,单 旭. 波浪作用下加固软基上大圆筒结构稳定性分析[J]. , 2010, 31(8): 2648-2654.
[7] 孙熙平,张宝华,张 强,王笑难. 重力式码头基床遭水流冲刷后的稳定性分析[J]. , 2010, 31(10): 3184-3190.
[8] 肖俊华 ,周国然 ,袁聚云 ,赵锡宏 . 高桩码头桩基负摩擦力现场试验研究 ——上海洋山深水港工程现场试验[J]. , 2008, 29(4): 1097-1102.
[9] 王 刚,陈 杨,张建民. 大圆筒结构倾覆稳定分析的有限元法[J]. , 2006, 27(2): 238-241.
[10] 李俊如 ,高建光 ,贺 涛 ,曾平喜 ,李海波 . 广西钦州港二期码头抛石基床的水下爆夯[J]. , 2003, 24(6): 917-921.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 张广明,刘 合,张 劲,吴恒安,王秀喜. 储层流固耦合的数学模型和非线性有限元方程[J]. , 2010, 31(5): 1657 -1662 .
[2] 徐 明,陈金锋,宋二祥. 陡坡寺中微风化料的大型三轴试验研究[J]. , 2010, 31(8): 2496 -2500 .
[3] 尹利华,王晓谋,张留俊. 天津软土土性指标概率分布统计分析[J]. , 2010, 31(S2): 462 -469 .
[4] 张春会,赵全胜,于永江. 考虑力学参数关联的非均质煤概率模型[J]. , 2011, 32(2): 564 -570 .
[5] 林达明,尚彦军,孙福军,孙元春,吴锋波,刘志强. 岩体强度估算方法研究及应用[J]. , 2011, 32(3): 837 -842 .
[6] 吴 剑,冯少孔,李宏阶. 钻孔成像中结构面自动判读技术研究[J]. , 2011, 32(3): 951 -957 .
[7] 鲁晓兵 ,张旭辉 ,崔 鹏. 碎屑流沿坡面运动的数值模拟[J]. , 2009, 30(S2): 524 -527 .
[8] 戴国亮,周香琴,刘云忠,刘立基,龚维明. 井筒式地下连续墙水平承载能力模型试验研究[J]. , 2011, 32(S2): 185 -189 .
[9] 谢其泰 ,郭俊志 ,王建力 ,陈于高. 单轴压缩下含倾斜单裂纹砂岩试件裂纹扩展量测研究[J]. , 2011, 32(10): 2917 -2922 .
[10] 俞 缙 ,王 海 ,郑春婷 ,蔡燕燕 ,宋 磊. 掺灰膨胀土表面吸附试验及吸水性验证[J]. , 2012, 33(1): 73 -77 .