有限宽切槽对CCNBD断裂试样应力强度因子的影响

›› 2004, Vol. 25 ›› Issue (3): 427-431.

有限宽切槽对CCNBD断裂试样应力强度因子的影响

戴峰，王启智

四川大学土木力学系，四川成都 610065

收稿日期:2002-12-30 出版日期:2004-03-10 发布日期:2014-07-15
作者简介:戴峰，男，1978年生，硕士，从事固体力学方面的研究。
基金资助:
国家自然科学基金（编号：19872046）资助项目

Effects of finite notch width on stress intensity factor for CCNBD specimen

DAI Feng，WANG Qi-zhi

Department of Civil Engineering and Applied Mechanics, Sichuan University, Chengdu 610065，China

Received:2002-12-30 Online:2004-03-10 Published:2014-07-15

摘要/Abstract

摘要： 国际岩石力学学会（ISRM）在1995年提出一种新型的岩石断裂韧度试样——人字形切槽巴西圆盘试样（cracked chevron notched Brazilian disc——CCNBD），对该试样的一个重要力学参数即最小无量纲应力强度因子的标定，以前的分析和计算都没有考虑切槽宽度的影响。然而试样切槽的宽度受切割刀具厚度所限，不能为零。当试样较小时，切槽宽度则相对较大。通过三维边界元计算分析表明，切槽宽度越大，无量纲应力强度因子的标定值就越大；对于ISRM推荐的CCNBD标准试样，得出其最小无量纲因子值为0.954，这比ISRM给出对应值0.84要大13.6 %。同时，小裂纹应力强度因子曲线的变化趋势也发生了质的变化，这可能会导致实验的失败。推荐最小无量纲应力强度因子的标定采用考虑切槽的三维分析。

关键词: 人字形切槽巴西圆盘（CCNBD）, 无量纲应力强度因子, 断裂韧度, 切槽宽度, FRANC3D

Abstract: International Society for Rock Mechanics ( ISRM ) proposed in 1995 a new type of rock fracture toughness specimen——cracked chevron notched Brazilian disk ( CCNBD ), the previous analytical and numerical studies of the dimensionless stress intensity factor, which is an important mechanicel parameter, does not take into account the effects of finite notch width. Since the minimum chevron notch width is limited by the size of the cutting wheels used to produce it and can not be zero, as the specimen size get small enough, the notch width would become large in relation to the sample size. Our 3D BEM(Boundary Element Method) calculation shows that the larger the notch width is, the bigger the error makes for the dimensionless stress intensity factor. To the standard CCNBD specimen suggested by ISRM, this paper determines the minimum dimensionless stress intensity factor to be 0.954 which is 13.6 % larger than the value 0.84 given by ISRM; and the tread of the curve is changed when the crack is short, this could make the failure of the experiment. We recommend that a full 3D numerical analysis taking into effect of the notch width to be done whenever determine the dimensionless stress intensity factor.

Key words: cracked chevron notched Brazilian disc(CCNBD), dimension stress intensity factor, fracture Toughness, notch width, FRANC3D

中图分类号:

TU 459

戴峰，王启智. 有限宽切槽对CCNBD断裂试样应力强度因子的影响[J]. , 2004, 25(3): 427-431.

DAI Feng，WANG Qi-zhi. Effects of finite notch width on stress intensity factor for CCNBD specimen[J]. , 2004, 25(3): 427-431.

参考文献

相关文章 15

[1]	张盛, 王龙飞, 常旭, 王东坤, 王小良, 乔洋, . 中心直裂纹半圆盘试样的石灰岩断裂韧度尺寸效应试验研究[J]. 岩土力学, 2019, 40(5): 1740-1749.
[2]	赵子江，刘大安，崔振东，唐铁吾，韩伟歌,. 半圆盘三点弯曲法测定页岩断裂韧度(KIC) 的实验研究[J]. , 2018, 39(S1): 258-266.
[3]	孟涛，胡耀青，付庆楠，冯淦，靳佩华,. 层状盐岩石膏夹层在腐蚀条件下断裂韧度试验及其弱化机制研究[J]. , 2017, 38(7): 1933-1942.
[4]	曹富，杨丽萍，李炼，刘恩龙，王启智, . 压缩单裂纹圆孔板（SCDC）岩石动态断裂全过程研究[J]. , 2017, 38(6): 1573-1582.
[5]	郭俊志，谢其泰，王建力,. 边缘裂缝圆盘砂岩试体III型断裂韧度量测之研究[J]. , 2016, 37(S1): 263-266.
[6]	华文，董世明，徐积刚. 复合型加载条件下锈岩断裂韧度试验研究[J]. , 2016, 37(3): 753-758.
[7]	戴峰，魏明东，徐奴文，许媛，赵涛. 岩石断裂韧度CCNSCB方法渐进破坏机制与无量纲应力强度因子宽范围标定[J]. , 2016, 37(11): 3215-3223.
[8]	苟小平，杨井瑞，王启智 . 基于P-CCNBD试样的岩石动态断裂韧度测试方法[J]. , 2013, 34(9): 2449-2459.
[9]	张盛，李新文，杨向浩 . 动载确定方法对岩石动态断裂韧度测试的影响[J]. , 2013, 34(9): 2721-2726.
[10]	刘增利，李洪升，邢怀念，张小鹏. 冻土非线性断裂韧度的修正因子测试方法[J]. , 2013, 34(3): 908-912.
[11]	邓华锋，朱敏，李建林，王宇，罗骞，原先凡. 砂岩Ⅰ型断裂韧度及其与强度参数的相关性研究[J]. , 2012, 33(12): 3585-3591.
[12]	崔振东，刘大安，安光明，周苗，李志清. V形切槽巴西圆盘法测定岩石断裂韧度KIC的实验研究[J]. , 2010, 31(9): 2743-2748.
[13]	刘晓洲，吴寅，王忠昶，李洪升，武俊杰. 基于能量平衡法的原状冻土Ⅰ型非线性断裂韧度测试研究[J]. , 2009, 30(S2): 83-87.
[14]	张盛，王启智. 用5种圆盘试件的劈裂试验确定岩石断裂韧度[J]. , 2009, 30(1): 12-18.
[15]	刘晓洲，王德刚，李洪升，叶辉 . 原状冻土非线性断裂韧度测试与修正[J]. , 2007, 28(8): 1533-1538.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed