›› 2011, Vol. 32 ›› Issue (S1): 388-0391.

• 基础理论与实验研究 • 上一篇    下一篇

不同干燥方法对重塑膨润土压汞试验用土样的影响试验研究

张 平1, 2,房营光1, 2,闫小庆1, 2,何智威1, 2   

  1. 1. 华南理工大学 土木与交通学院,广州 510640;2. 华南理工大学 亚热带建筑科学国家重点实验室,广州 510640)
  • 收稿日期:2010-08-16 出版日期:2011-05-15 发布日期:2011-05-16
  • 作者简介:张平,男,1985年生,硕士研究生,主要从事土体微结构方面的研究
  • 基金资助:

    亚热带建筑科学国家重点实验室自主项目(No. 2008ZA11)。

Study of different dry methods for drying remolded bentonite sample with mercury intrusion test

ZHANG Ping1, 2, FANG Ying-guang1, 2, YAN Xiao-qing1, 2, HE Zhi-wei1, 2   

  1. 1. School of Civil Engineering and Transportation, South China University of Technology, Guangzhou 510640, China; 2. State Key Laboratory of Subtropical Building Science, South China University of Technology, Guangzhou 510640, China
  • Received:2010-08-16 Online:2011-05-15 Published:2011-05-16

摘要: 采用风干法、烘干法和冻干法分别对不同含水率的重塑膨润土进行干燥制样,利用压汞试验得到的累积进汞量曲线,对重塑膨润土进行了孔隙尺度划分,根据测试结果对土样孔隙尺度分布特征进行了定量分析。试验结果表明:采用风干法、烘干法和冻干法干燥制样后土体孔隙分布存在较大的差异性,土样的含水率越高,差异越明显;风干法、烘干法干燥土样会引起孔隙收缩,导致土体微孔隙特征的变化,冻干法不会引起孔隙收缩,因而不会导致土体微孔隙特征的变化。由此得出了干燥重塑膨润土制备压汞试验用土样最好的干燥方法是冻干法这一结论

关键词: 孔隙尺度, 风干法, 烘干法, 冻干法, 压汞试验

Abstract: The remolded bentonite samples with different water contents were prepared after drying with air dry method, drying method and freeze dry method. Their cumulative intrusion curves were obtained with mercury intrusion test. The division of pore scale for remolded bentonite samples were made according to the test result; then the quantitative analysis of pore criterion distribution characteristics was made according to the test result. The results show that the pore diameters and pore-scale distributions of soil prepared by air dry method, drying method and freeze dry method are great different. The higher of water content is, the more obvious difference is; the pore diameter of soil prepared by air dry method and drying method become small, causes the change of micropore characteristic; the pore diameter of soil prepared by freeze dry method does not become small, so does not cause the change of micropore characteristic. And the conclusion is drawn that the freeze dry method is the best method for drying remolded bentonite sample using mercury intrusion test.

Key words: pore scale, air dry method;drying method, freeze dry method, mercury intrusion test

中图分类号: 

  • TU 411
[1] 雷华阳, 胡垚, 雷尚华, 祁子洋, 许英刚, . 增压式真空预压加固吹填超软土微观结构特征分析[J]. 岩土力学, 2019, 40(S1): 32-40.
[2] 牛 庚,孙德安,韦昌富,颜荣涛,. 基于孔径分布的全风化泥岩持水曲线推算[J]. , 2018, 39(4): 1337-1345.
[3] 孙德安,何家浩,高 游. 广吸力范围内压实红黏土的强度特性[J]. , 2017, 38(S2): 51-56.
[4] 陈 波,孙德安,高 游,李 健,. 上海软黏土的孔径分布试验研究[J]. , 2017, 38(9): 2523-2530.
[5] 武亚军,牛 坤,唐海峰,胡志刚,陆逸天,. 药剂真空预压法处理工程废浆中生石灰的增渗作用[J]. , 2017, 38(12): 3453-3461.
[6] 黄启迪,蔡国庆,赵成刚, . 非饱和土干化过程微观结构演化规律研究[J]. , 2017, 38(1): 165-173.
[7] 吴朱敏,吕擎峰,王生新,. 复合改性水玻璃加固黄土微观特征研究[J]. , 2016, 37(S2): 301-308.
[8] 王彦兵 ,王思敬 ,李 黎 ,王旭东 ,李最雄,. 硅酸钾对遗址土的渗透加固机制及改进特性研究[J]. , 2014, 35(3): 696-704.
[9] 张先伟 ,孔令伟 ,郭爱国 ,拓勇飞,. 不同固结压力下强结构性黏土孔隙分布试验研究[J]. , 2014, 35(10): 2794-2800.
[10] 李小春,付 旭,方志明,胡海翔. 有效应力对煤吸附特性影响的试验研究[J]. , 2013, 34(5): 1247-1252.
[11] 曾召田 ,吕海波 ,赵艳林 ,王志兵 . 膨胀土干湿循环过程孔径分布试验研究及其应用[J]. , 2013, 34(2): 322-328.
[12] 丁建文,洪振舜,刘松玉. 疏浚淤泥流动固化土的压汞试验研究[J]. , 2011, 32(12): 3591-3596.
[13] 刘 琦,卢耀如,张凤娥,齐继祥,张 胜. 温度与动水压力作用下灰岩微观溶蚀的定性分析[J]. , 2010, 31(S2): 149-154.
[14] 周 晖,房营光,曾 铖. 广州饱和软土固结过程微孔隙变化的试验分析[J]. , 2010, 31(S1): 138-144.
[15] 蒋明镜,彭立才,朱合华,林奕禧,黄良机. 珠海海积软土剪切带微观结构试验研究[J]. , 2010, 31(7): 2017-2023.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 刘小文,常立君,胡小荣. 非饱和红土基质吸力与含水率及密度关系试验研究[J]. , 2009, 30(11): 3302 -3306 .
[2] 黄建华,宋二祥. 大型锚碇基础围护工程冻结帷幕力学性态研究[J]. , 2009, 30(11): 3372 -3378 .
[3] 王观石,李长洪,陈保君,李世海. 应力波在非线性结构面介质中的传播规律[J]. , 2009, 30(12): 3747 -3752 .
[4] 王朝阳,许 强,倪万魁. 原状黄土CT试验中应力-应变关系的研究[J]. , 2010, 31(2): 387 -391 .
[5] 邓 琴,郭明伟,李春光,葛修润. 基于边界元法的边坡矢量和稳定分析[J]. , 2010, 31(6): 1971 -1976 .
[6] 万少石,年廷凯,蒋景彩,栾茂田. 边坡稳定强度折减有限元分析中的若干问题讨论[J]. , 2010, 31(7): 2283 -2288 .
[7] 闫 铁,李 玮,毕雪亮. 基于分形方法的多孔介质有效应力模型研究[J]. , 2010, 31(8): 2625 -2629 .
[8] 徐维生,柴军瑞,陈兴周,孙旭曙. 岩体裂隙网络非线性非立方渗流研究与应用[J]. , 2009, 30(S1): 53 -57 .
[9] 赵尚毅,郑颖人,李安洪,邱文平,唐晓松,徐 俊. 多排埋入式抗滑桩在武隆县政府滑坡中的应用[J]. , 2009, 30(S1): 160 -164 .
[10] 刘振平,贺怀建,朱发华. 基于钻孔数据的三维可视化快速建模技术的研究[J]. , 2009, 30(S1): 260 -266 .