›› 2011, Vol. 32 ›› Issue (6): 1891-1897.

• 数值分析 • 上一篇    下一篇

TBM滚刀破岩过程影响因素数值模拟研究

孙金山1, 2,陈 明3,陈保国1, 2,卢文波3,周传波1   

  1. 1. 中国地质大学(武汉)岩土钻掘与防护教育部工程研究中心,武汉 430074;2. 中国地质大学(武汉)工程学院,武汉 430074; 3. 武汉大学 水资源与水电工程科学国家重点试验室,武汉 430072
  • 收稿日期:2007-09-21 出版日期:2011-06-10 发布日期:2011-06-21
  • 作者简介:孙金山,男,1980年生,博士,讲师,主要从事岩土与地质工程方面研究
  • 基金资助:

    国家自然科学基金资助项目(No. 50725931,No. 50839004,No. 50909077);中国地质大学(武汉)优秀青年教师基金资助项目(No. CUGL090218,No. CUGL090212)

Numerical simulaiton of influence factors for rock fragmentation by TBM cutters

SUN Jin-shan1, 2, CHEN Ming3, CHEN Bao-guo1, 2, LU Wen-bo3, ZHOU Chuan-bo1   

  1. 1. Engineering Research Center of Rock-Soil Drilling & Excavation and Protection of Ministry of Education, China University of Geosciences (Wuhan), Wuhan 430074, China; 2. Faculty of Engineering, China University of Geosciences (Wuhan), Wuhan 430074, China; 3. State Key Laboratory of Water Resources and Hydropower Engineering Science, Wuhan University, Wuhan 430072, China
  • Received:2007-09-21 Online:2011-06-10 Published:2011-06-21

摘要: 全断面岩石掘进机(TBM)的破岩效率主要受刀盘设计和岩体特征的影响。采用颗粒流方法建立了岩石试件与滚刀的数值模型,对TBM滚刀破岩过程的影响因素进行了分析。研究表明,单刃滚刀交替作用下强度较低的岩石中易形成规则的张拉裂纹而生成较大岩碴;强度较高的岩石中滚刀的侧向挤压促使形成块度较小的片状岩碴;双刃滚刀作用下岩石表面受到强烈挤压后出现较大的拉应力,使岩石更易破碎,且仅在强度较高的岩石中才易形成透镜状岩碴。滚刀破岩过程中存在能耗最小的最佳间距,该最佳间距随着岩石强度的增大而减小。滚刀破岩过程中,结构面对裂纹扩展具有显著的控制性作用,并阻隔损伤向结构面下的岩石中渗透;随着结构面与滚刀侵入方向夹角的减小,结构面将引导裂纹向岩石深部扩展,而当夹角较大时,结构面则会引导裂纹横向扩展,易导致大块岩碴的形成

关键词: 全断面岩石掘进机(TBM), 滚刀, 破岩, 颗粒流法, 数值模拟

Abstract: The cutterhead and rock mass characteristics affect the excavation efficiency of full face rock tunnel boring machine (TBM) strongly. The numerical models are made by the particle flow code method (PFC2D) to simulate the rock fragmentation under TBM disc cutters. Numerical simulation tests show that some factors influence the rock fragmentation process strongly. In the relative weak rocks, the regular tension cracks and the big mucks form more easily, when the disc cutters penetrate rocks alternately; in hard rocks, the formation of small disc shape mucks depends on the lateral extrusion of cutter rings. Under the double disc cutters, the rocks crush more easily because of the tension stress which comes form strong compression of cutters, and the disc shape mucks only form in very hard rocks. There is optimal cutter spacing for different strength rocks, which increase with rock strength decreases. In the process of rock fragmentation, discontinuities control the propagation process of cracks and obstruct the cracks spread to the underside of discontinuities. The discontinuities will guide the cracks spread deep in rocks, when the angle of cut-in direction and discontinuity decreases. And the discontinuities will guide the cracks spread transversely when the angle increases

Key words: tunnel boring machine(TBM), cutter, rock fragmentation, particle flow code method, numerical simulation

中图分类号: 

  • TU 443
[1] 李翻翻, 陈卫忠, 雷江, 于洪丹, 马永尚, . 基于塑性损伤的黏土岩力学特性研究[J]. 岩土力学, 2020, 41(1): 132-140.
[2] 夏 坤, 董林, 蒲小武, 李璐, . 黄土塬地震动响应特征分析[J]. 岩土力学, 2020, 41(1): 295-304.
[3] 郭院成, 李明宇, 张艳伟, . 预应力锚杆复合土钉墙支护体系增量解析方法[J]. 岩土力学, 2019, 40(S1): 253-258.
[4] 闫国强, 殷跃平, 黄波林, 张枝华, 代贞伟, . 三峡库区巫山金鸡岭滑坡成因机制与变形特征[J]. 岩土力学, 2019, 40(S1): 329-340.
[5] 刘红岩. 宏细观缺陷对岩体力学特性及边坡稳定影响研究[J]. 岩土力学, 2019, 40(S1): 431-439.
[6] 金爱兵, 刘佳伟, 赵怡晴, 王本鑫, 孙浩, 魏余栋, . 卸荷条件下花岗岩力学特性分析[J]. 岩土力学, 2019, 40(S1): 459-467.
[7] 韩征, 粟滨, 李艳鸽, 王伟, 王卫东, 黄健陵, 陈光齐, . 基于HBP本构模型的泥石流动力过程SPH数值模拟[J]. 岩土力学, 2019, 40(S1): 477-485.
[8] 吴锦亮, 何吉, . 岩质边坡动态开挖模拟的复合单元模型[J]. 岩土力学, 2019, 40(S1): 535-540.
[9] 吴凤元, 樊赟赟, 陈剑平, 李军, . 基于不同侵蚀模型的高速崩滑碎屑 流动力过程模拟分析[J]. 岩土力学, 2019, 40(8): 3236-3246.
[10] 孙峰, 薛世峰, 逄铭玉, 唐梅荣, 张翔, 李川, . 基于连续损伤的水平井射孔-近井筒三维破裂模拟[J]. 岩土力学, 2019, 40(8): 3255-3261.
[11] 穆锐, 浦少云, 黄质宏, 李永辉, 郑培鑫, 刘 旸, 刘 泽, 郑红超, . 土岩组合岩体中抗拔桩极限承载力的确定[J]. 岩土力学, 2019, 40(7): 2825-2837.
[12] 金俊超, 佘成学, 尚朋阳. 基于应变软化指标的岩石非线性蠕变模型[J]. 岩土力学, 2019, 40(6): 2239-2246.
[13] 张 聪, 梁经纬, 阳军生, 曹 磊, 谢亦朋, 张贵金, . 堤坝脉动注浆浆液扩散机制及应用研究[J]. 岩土力学, 2019, 40(4): 1507-1514.
[14] 严 健, 何 川, 汪 波, 蒙 伟, . 高地温对隧道岩爆发生的影响性研究[J]. 岩土力学, 2019, 40(4): 1543-1550.
[15] 李世俊, 马昌慧, 刘应明, 韩玉珍, 张 彬, 张 嘎, . 离心模型试验与数值模拟相结合研究 采空边坡渐进破坏特性[J]. 岩土力学, 2019, 40(4): 1577-1583.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 王 刚,李术才,王明斌. 渗透压力作用下加锚裂隙岩体围岩稳定性研究[J]. , 2009, 30(9): 2843 -2849 .
[2] 刘玉成,曹树刚,刘延保. 可描述地表沉陷动态过程的时间函数模型探讨[J]. , 2010, 31(3): 925 -931 .
[3] 介玉新,杨光华. 基于广义位势理论的弹塑性模型的修正方法[J]. , 2010, 31(S2): 38 -42 .
[4] 杨建民,郑 刚. 基坑降水中渗流破坏归类及抗突涌验算公式评价[J]. , 2009, 30(1): 261 -264 .
[5] 周 华,王国进,傅少君,邹丽春,陈胜宏. 小湾拱坝坝基开挖卸荷松弛效应的有限元分析[J]. , 2009, 30(4): 1175 -1180 .
[6] 叶 飞,朱合华,何 川. 盾构隧道壁后注浆扩散模式及对管片的压力分析[J]. , 2009, 30(5): 1307 -1312 .
[7] 罗 强 ,王忠涛 ,栾茂田 ,杨蕴明 ,陈培震. 非共轴本构模型在地基承载力数值计算中若干影响因素的探讨[J]. , 2011, 32(S1): 732 -0737 .
[8] 王云岗 ,章 光 ,胡 琦. 斜桩基础受力特性研究[J]. , 2011, 32(7): 2184 -2190 .
[9] 龚维明,黄 挺,戴国亮. 海上风电机高桩基础关键参数试验研究[J]. , 2011, 32(S2): 115 -121 .
[10] 汪成兵. 均质岩体中隧道围岩破坏过程的试验与数值模拟[J]. , 2012, 33(1): 103 -108 .