›› 2014, Vol. 35 ›› Issue (S2): 548-555.

• 岩土工程研究 • 上一篇    下一篇

开挖黄土高边坡的应力路径及变形破坏机制分析

侯晓坤1,李同录1, 2,李 萍1, 2   

  1. 1. 长安大学 地质工程与测绘学院,西安 710054; 2. 中国地质调查局西安地质调查中心 国土资源部黄土地质灾害重点试验室,西安 710054
  • 收稿日期:2014-06-19 出版日期:2014-10-31 发布日期:2014-11-12
  • 作者简介:侯晓坤,女,硕士研究生,主要从事非饱和黄土及边坡稳定性方面的研究工作。
  • 基金资助:

    国家自然科学基金(No. 41372329);国家重点基础研究发展计划(973计划)资助项目(No. 2014CB744701)。

Analysis of stress path and deformation-failure mechanism of high cutting loess slope

HOU Xiao-kun1,LI Tong-lu1, 2,LI Ping1, 2   

  1. 1. School of Geological Engineering and Surveying, Chang’an University, Xi’an 710054, China; 2. Key Laboratory for Geo-hazards in Loess Area of Ministry of Land and Resources, Xi’an Center of Geological Survey, China Geological Survey, Xi’an 710054, China
  • Received:2014-06-19 Online:2014-10-31 Published:2014-11-12

摘要: 采用室内试验与数值计算相结合的方法研究开挖形成的黄土高边坡的稳定性及破坏机制。以甘肃环县华能电厂人工高边坡为例,采用线弹性有限元模拟分级开挖过程中潜在破坏面上的应力路径,在边坡上取代表性土样,参考此应力路径做天然含水率和饱和含水率下的三轴试验。依据试验所得强度参数,建立不同开挖坡比下的弹塑性有限元模型,计算各开挖阶段潜在滑动面上土体的应力状态,揭示边坡的破坏机制。结果表明,开挖过程中边坡潜在破坏面上土体应力路径为平均应力减小,剪应力先减小、后增大;开挖过程对潜在破坏面作用为先卸载、后加载,当开挖坡比较大时,高边坡坡肩处先发生屈服破坏,屈服范围随着开挖深度的增大逐渐向下扩展,直至形成连通的屈服面,为典型的推移式破坏模式。

关键词: 黄土, 高边坡, 开挖, 应力路径, 三轴剪切试验, 有限元, 推移式破坏模式

Abstract: This paper adopts laboratory experiments and numerical calculation to analyze the stability of high cutting loess slope. Taking the cutting slope in the site of Huanneng electrical plant ,which islocated in Huanxian county, Gansu province , as an example, the linear elastic finite element method is utilized to attain the stress path of soil mass on the potential failure surface under multistage excavation. Then based on this stress path, triaxial shear tests are conducted on specimens with two moisture contents. With the strength parameters obtained from these tests, elastic-plastic finite element models against different excavation ratios are made to figure out its stress field. Afterwards comparison between the shear strength and shear stress on the slide surface reveals the mechanism of slope failure. Results show that the stress path (in p-q space) of soil on the prospective failure surface displays a trend that the mean stress p decreases with excavation while the shear stress q decreases at first then increases slowly. The effect of excavation on the potential surface changes from unloading at the beginning to loading. Failure firstly occurs at the shoulder of the high slope and then expands to lower area with the excavation process until a connecting yield surface in the slope develops. This mechanism is typical of top-driving landslide mechanism.

Key words: loess, high slope, excavation, stress path, triaxial shear tests, finite elements, top-driving landslide mode

中图分类号: 

  • TU 443
[1] 王国辉, 陈文化, 聂庆科, 陈军红, 范晖红, 张川, . 深厚淤泥质土中基坑开挖对基桩 影响的离心模型试验研究[J]. 岩土力学, 2020, 41(2): 399-407.
[2] 方瑾瑾, 冯以鑫, 王立平, 余永强, . 真三轴条件下非饱和黄土的有效应力屈服特性[J]. 岩土力学, 2020, 41(2): 492-500.
[3] 闫超萍, 龙志林, 周益春, 旷杜敏, 陈佳敏, . 钙质砂剪切特性的围压效应和粒径效应研究[J]. 岩土力学, 2020, 41(2): 581-591.
[4] 魏纲, 张鑫海, 林心蓓, 华鑫欣, . 基坑开挖引起的旁侧盾构隧道横向受力变化研究[J]. 岩土力学, 2020, 41(2): 635-644.
[5] 孙锐, 杨峰, 阳军生, 赵乙丁, 郑响凑, 罗静静, 姚捷, . 基于二阶锥规划与高阶单元的 自适应上限有限元研究[J]. 岩土力学, 2020, 41(2): 687-694.
[6] 柯锦福, 王水林, 郑宏, 杨永涛, . 基于修正对称和反对称分解的 三维数值流形元法应用推广[J]. 岩土力学, 2020, 41(2): 695-706.
[7] 夏 坤, 董林, 蒲小武, 李璐, . 黄土塬地震动响应特征分析[J]. 岩土力学, 2020, 41(1): 295-304.
[8] 何鹏飞, 马巍, 穆彦虎, 黄永庭, 董建华, . 黄土−砂浆块界面剪切特性试验及本构模型研究[J]. 岩土力学, 2019, 40(S1): 82-90.
[9] 刘华, 张硕成, 牛富俊, 邵珠山, 牛泽林, 鲁洁, . 酸碱污染Q3黄土的一维压缩特征试验研究[J]. 岩土力学, 2019, 40(S1): 210-216.
[10] 丁智, 张霄, 金杰克, 王立忠, . 基坑全过程开挖及邻近地铁隧道变形实测分析[J]. 岩土力学, 2019, 40(S1): 415-423.
[11] 叶观宝, 郑文强, 张 振, . 大面积填土场地中摩擦型桩负摩阻力分布特性研究[J]. 岩土力学, 2019, 40(S1): 440-448.
[12] 吴锦亮, 何吉, . 岩质边坡动态开挖模拟的复合单元模型[J]. 岩土力学, 2019, 40(S1): 535-540.
[13] 侯公羽, 荆浩勇, 梁金平, 张广东, 谭金鑫, 张永康, 杨希, . 不同卸荷速率下矩形巷道变形及 声发射特性试验研究[J]. 岩土力学, 2019, 40(9): 3309-3318.
[14] 孔亮, 刘文卓, 袁庆盟, 董彤, . 常剪应力路径下含气砂土的三轴试验[J]. 岩土力学, 2019, 40(9): 3319-3326.
[15] 赵密, 欧阳文龙, 黄景琦, 杜修力, 赵旭, . P波作用下跨断层隧道轴线地震响应分析[J]. 岩土力学, 2019, 40(9): 3645-3655.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 陶干强,杨仕教,任凤玉. 崩落矿岩散粒体流动性能试验研究[J]. , 2009, 30(10): 2950 -2954 .
[2] 张文杰,陈云敏. 垃圾填埋场抽水试验及降水方案设计[J]. , 2010, 31(1): 211 -215 .
[3] 宫伟力,安里千,赵海燕,毛灵涛. 基于图像描述的煤岩裂隙CT图像多尺度特征[J]. , 2010, 31(2): 371 -376 .
[4] 万 智,董 辉,刘宝琛. 基于正交设计下SVM滑坡变形时序回归预测的超参数选择[J]. , 2010, 31(2): 503 -508 .
[5] 孙曦源,栾茂田,唐小微. 饱和软黏土地基中桶形基础水平承载力研究[J]. , 2010, 31(2): 667 -672 .
[6] 王明年,郭 军,罗禄森,喻 渝,杨建民,谭忠盛. 高速铁路大断面黄土隧道深浅埋分界深度研究[J]. , 2010, 31(4): 1157 -1162 .
[7] 胡勇刚,罗 强,张 良,黄 晶,陈亚美. 基于离心模型试验的水泥土搅拌法加固斜坡软弱土地基变形特性分析[J]. , 2010, 31(7): 2207 -2213 .
[8] 谭峰屹,姜志全,李仲秋,颜惠和. 附加质量法在昆明新机场填料压实密度检测中的应用研究[J]. , 2010, 31(7): 2214 -2218 .
[9] 柴 波,殷坤龙,肖拥军. 巴东新城区库岸斜坡软弱带特征[J]. , 2010, 31(8): 2501 -2506 .
[10] 杨召亮,孙冠华,郑 宏. 基于潘氏极大值原理的边坡稳定性的整体分析法[J]. , 2011, 32(2): 559 -563 .