岩石锚杆基础抗拔承载力计算方法探究

›› 2009, Vol. 30 ›› Issue (S1): 75-78.

岩石锚杆基础抗拔承载力计算方法探究

孙长帅^1，2，杨海巍³，徐光黎^1，2

1. 中国地质大学（武汉）工程学院，武汉 430074；2. 中国地质大学岩土钻掘与防护教育部工程研究中心，武汉 430074； 3. 河北省电力勘测设计研究院，石家庄 050031

收稿日期:2009-06-01 出版日期:2009-08-10 发布日期:2011-03-16
作者简介:孙长帅，男，1986年生，硕士研究生，主要从事岩土体稳定性评价方面的研究。

Researches on pull-out capacity calculating method of rock bolt foundation

SUN Chang-shuai ^{1, 2}, YANG Hai-wei³, XU Guang-li ^{1, 2}

1. Engineering Faculty, China University of Geosciences, Wuhan 430074, China; 2. Engineering Research Center of Rock-Soil Drilling & Excavation and Protection, Ministry of Education, China University of Geosciences, Wuhan 430074, China; 3. Hebei Electric Power Design & Research Institute, Shijiazhuang 050031, China

Received:2009-06-01 Online:2009-08-10 Published:2011-03-16

摘要/Abstract

摘要：

岩石锚杆基础作为架空输电线路塔基中的一种特殊基础型式，可以充分发挥原状岩体的力学性能，具有良好的抗拔性能。根据目前岩石锚杆基础原型试验的结果，《架空送电线路基础设计技术规定》中所推荐的单锚基础抗拔承载力计算模型中，理想45?破坏模式与实际不符，按其设计计算值偏差较大，可能导致设计成果不安全。为此，依据极限平衡原理基于围岩强度建立了较为合理的抗拔承载力计算模型，力学推导得出了相关公式，并进行了简化。通过推导公式计算值与实测值、设计值对比验证可知，抗拔承载力极限值位于～区间内，与推荐公式的计算值一致性较好，能满足工程应用精度，具有可行性。

关键词: 岩石锚杆基础, 抗拔承载力, 计算方法

Abstract:

As a special type of the tower-foundation in overhead transmission lines, the rock bolt foundation can give full play to the mechanical properties of rock masses in original state and provide a good pull-out performance. The results of the current prototype test of rock bolt foundation show that in the calculating model of the single anchor foundation’s pull-out capacity which is recommended in The technical requirements in overhead transmission lines foundation design, the hypothetical model of the ideal 45? does not match the actual damage. The calculation based on it makes larger deviations and the results may lead to unsafe design. To this end, based on the limit equilibrium principle and rock intensity, a more reasonable pull-out capacity calculating model, is established, and the relevant formula by mechanical derivation is obtained and simplified. Through the comparison and verification among the calculated values based on derived formula, actual values and designed values, the pull-out capacity is located in range limits and in good consistency with the calculated values of recommended formula . The results are feasible and able to meet the precision of engineering applications better.

Key words: rock bolt foundation, pull-out capacity, calculation method

中图分类号:

TU 443

孙长帅，杨海巍，徐光黎. 岩石锚杆基础抗拔承载力计算方法探究[J]. , 2009, 30(S1): 75-78.

SUN Chang-shuai, YANG Hai-wei, XU Guang-li. Researches on pull-out capacity calculating method of rock bolt foundation[J]. , 2009, 30(S1): 75-78.

参考文献

相关文章 15

[1]	邓涛, 林聪煜, 柳志鹏, 黄明, 陈文菁, . 大位移条件下水平受荷单桩的简明弹塑性计算方法[J]. 岩土力学, 2020, 41(1): 95-102.
[2]	章定文, 刘志祥, 沈国根, 鄂俊宇, . 超大直径浅埋盾构隧道土压力实测分析及其计算方法适用性评价[J]. 岩土力学, 2019, 40(S1): 91-98.
[3]	戴国亮, 朱文波, 郭晶, 龚维明, 赵学亮, . 软黏土中吸力式沉箱基础竖向抗拔承载特性试验研究[J]. 岩土力学, 2019, 40(S1): 119-126.
[4]	王钦科, 马建林, 陈文龙, 杨彦鑫, 胡中波, . 上覆土嵌岩扩底桩抗拔承载特性离心模型试验及计算方法研究[J]. 岩土力学, 2019, 40(9): 3405-3415.
[5]	李瑞山, 袁晓铭. 成层场地基本周期简化计算方法研究[J]. 岩土力学, 2019, 40(8): 3227-3235.
[6]	马文冠, 刘润, 练继建, 郭绍曾. 粉土中筒型基础贯入阻力的研究[J]. 岩土力学, 2019, 40(4): 1307-1312.
[7]	周同和, 郜新军, 郭院成, 孙轶斌, . 下部扩大段复合桩抗拔承载力设计方法与试验研究[J]. 岩土力学, 2019, 40(10): 3778-3782.
[8]	熊晓荣，汤华，廖明进，尹小涛，王东英, . 隧道锚“楔形效应”的室内模型试验研究[J]. , 2018, 39(S1): 181-190.
[9]	金亚兵. 地连墙槽壁加固深度和宽度计算方法研究[J]. , 2017, 38(S2): 273-278.
[10]	金亚兵. 地连墙槽壁加固稳定性计算方法研究[J]. , 2017, 38(S1): 305-312.
[11]	张永杰，夏旖琪，冯夏庭，王桂尧，. 陡坡段双桩-柱基础简化计算方法及影响因素分析[J]. , 2017, 38(6): 1705-1715.
[12]	崔强，孟宪乔，杨少春,. 扩径率与入岩深度对岩基挖孔基础抗拔承载特性影响的试验研究[J]. , 2016, 37(S2): 195-202.
[13]	崔强，周亚辉，童瑞铭，吉晔. 上拔扩底基础与地基土体承载特性差异性分析[J]. , 2016, 37(S2): 476-482.
[14]	周云涛 . 三峡库区危岩稳定性断裂力学计算方法[J]. , 2016, 37(S1): 495-499.
[15]	张昕，乐金朝，刘汉东,. 砂土中群锚锚周土体变形特性模型试验研究[J]. , 2016, 37(S1): 240-248.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed